MP 277 - Service, Support Download

Configuring the device
6.4 Changing settings for operation
1. Touch the "Recalibrate" button to open the following dialog:
2. Briefly touch the middle of the calibration crosshairs ①.
The calibration crosshairs is then displayed at four more positions. Touch the middle of
the calibration crosshairs for each position. If you do not touch the middle of the
calibration crosshairs, the procedure is repeated.
Once you have touched the calibration crosshairs for all positions, the following dialog
3. Touch the touch screen within 30 seconds.
The new calibration is saved. If you wait longer than 30 seconds, the new calibration is
discarded and the original calibration remains in effect.
The "OP Properties" dialog , "Touch" tab is displayed again.
4. Close the dialog.
The touch screen of the HMI device is recalibrated.
MP 277
Operating Instructions, 07/2014, A5E02479740-02