MP 277 - Service, Support Download

Transcript
Configuring the device
6.10 Change the communication settings
6.10.2
Configuring the data channel
If you block all data channels, the HMI device is protected against unintentional overwriting
of the project data and HMI device image.
Note
A project can only be transferred from the configuration PC to the HMI device when at least
one of the data channels is enabled on the HMI device.
Requirement
You have opened the "Transfer Settings" dialog box with the "Transfer Settings" icon.
①
②
③
Group for data channel 1 (Channel 1)
Group for data channel 2 (Channel 2)
Button for the dialog "S7 Transfer Settings" or "Network and Dial-Up Connections."
The "Directories" tab is described in the section "Setting the Delay Time (Page 102)".
Note
Changes during "Transfer" mode
If the change transfer settings during "Transfer" mode, the changed transfer settings will not
into effect until the next time you start the transfer.
This may occur if the Control Panel is opened to change the transfer properties in an active
project.
MP 277
Operating Instructions, 07/2014, A5E02479740-02
109