MP 277 - Service, Support Download

Transcript
Commissioning a project
7.5 Transfer project to the HMI device
7.5
Transfer project to the HMI device
7.5.1
Transfer project with WinCC
7.5.1.1
Setting the transfer mode
Introduction
You can start the "Transfer" mode manually or automatically on the HMI device.
If the automatic transfer is enabled, the HMI device automatically switches to "Transfer"
mode when the following event occurs during runtime: You start project transfer on the
connected configuration PC.
Note
With automatic transfer, the HMI device only switches to "Transfer" mode when the project is
running on the HMI device.
Automatic transfer is particularly suited for the test phase of a new project because the
transfer is completed without interfering with the HMI device.
Note
If automatic transfer is activated on the HMI device and a transfer is initiated on the
configuration PC, the project currently running is automatically stopped. The HMI device then
automatically switches to "Transfer" mode.
After the commissioning phase, deactivate the automatic transfer so that the HMI device
cannot be inadvertently switched to transfer mode. The transfer mode can trigger
unintentional reactions in the system.
You can issue a password in the Control Panel to restrict access to the transfer settings and
thus avoid unauthorized modifications.
Requirement
● The Control Panel is open.
● The Runtime software is terminated.
MP 277
Operating Instructions, 07/2014, A5E02479740-02
137
Similar
MP 277 - Service, Support
MP 277 - Service, Support
WirelessKey PROFESSIONAL manual
WirelessKey PROFESSIONAL manual
Descarga  - Service, Support
Descarga - Service, Support
X5 line c - Ascon S.p.A.
X5 line c - Ascon S.p.A.
"user manual"
Visualization of Dispatching Strategies
Visualization of Dispatching Strategies
TP 277, OP 277 (WinCC flexible) - Service, Support
TP 277, OP 277 (WinCC flexible) - Service, Support
Operating Instructions HMI device MP 177 (WinCC flexible)
Operating Instructions HMI device MP 177 (WinCC flexible)
Catalog ST 80 / ST PC 2010
Catalog ST 80 / ST PC 2010
SIMATIC HMI HMI Device TP 177A, TP 177B, OP
SIMATIC HMI HMI Device TP 177A, TP 177B, OP
900 kB - Nexus Marine
900 kB - Nexus Marine
- Murdoch Research Repository
- Murdoch Research Repository
X1 line c
X1 line c
"user manual"
WinAC RTX ODK User Manual - Service, Support
WinAC RTX ODK User Manual - Service, Support
RPX Lite (RPXL_CW), User Manual
RPX Lite (RPXL_CW), User Manual
Simatic S7-200
Simatic S7-200
SIMATIC HMI HMI device MP 377 (WinCC flexible)
SIMATIC HMI HMI device MP 377 (WinCC flexible)
Operator Control and Monitoring Devices
Operator Control and Monitoring Devices
NETLink PRO Compact Handbuch
NETLink PRO Compact Handbuch
Mobile Panel 277 RO - Service, Support
Mobile Panel 277 RO - Service, Support
KT4H Temperature Controller
KT4H Temperature Controller