MP 277 - Service, Support Download

Transcript
Commissioning a project
7.7 Updating the operating system
5. Set "Transfer" mode on the HMI device.
If automatic transfer mode is enabled on the HMI device, the device automatically sets
"Transfer" mode when a restore operation is initiated.
6. Start the restore operation in ProSave on the PC with "Start Restore".
Follow the instructions in ProSave.
A status view opens to indicate the progress of the operation.
Result
When the restore is successfully completed, the data backed up on the PC is now on the
HMI device.
See also
Overview (Page 147)
Data Transmission Options (Page 136)
Operating modes (Page 134)
Configuring the data channel (Page 109)
7.7
Updating the operating system
7.7.1
Overview
A compatibility conflict may occur when transferring a project to the HMI device. This is
caused by different versions of the configuration software used and the HMI device image
available on the HMI device. If there are different versions, the transfer is aborted. A
message indicating a compatibility conflict is displayed on the configuration PC.
There are two ways to match the versions:
● Update the HMI device image if the project was created with a more recent version of the
configuration software.
● Transfer a matching version of the HMI device image if you do not want to adapt the
project for the HMI device to the current version of the configuration software for the
project.
MP 277
Operating Instructions, 07/2014, A5E02479740-02
149