MP 277 - Service, Support Download

Transcript
Configuring the device
6.1
6
Loader
The following figure shows the loader.
The loader buttons have the following functions:
● Press the "Transfer" button to set the HMI device to "Transfer" mode.
The transfer mode can only be activated when at least one data channel has been
enabled for the transfer.
● Press the "Start" button to start the project on the HMI device.
If you do not perform an operation, the project on the HMI device will automatically start
after a delay.
MP 277
Operating Instructions, 07/2014, A5E02479740-02
69