Download Incowin User Manual

Transcript
Description of the Components
2.2.5
Assembly Holder
For setting, testing and maintenance procedures the V-INCOMETER is
clamped into an assembly holder.
1
Fig. 2-15: V-INCOMETER in assembly holder
1 - assembly holder with snap catch
To clamp, open the snap catch and position the V-INCOMETER, as
shown in Fig. 2-15.
346H
Close the snap catch again.
2.3
Electronics Unit
2.3.1
Overview
The electronics unit contains all the hardware components necessary
for controlling the V-INCOMETER. It is connected to the VINCOMETER by the probe cable and to the evaluation computer with a
serial cable via an integrated interface. It receives control commands
from the computer via this interface which are processed in the electronics. There, signals for the step motors are generated and amplified
in power output stages which move the measuring head to the desired axial and radial position. The analogue probe signal is displayed
on an instrument on the front panel of the electronics and digitised by
an A/D converter. LEDs on the front panel serve for status control of VINCOMETER and electronics. A probe display indicates the connected
and active probes.
ID 10034503
V-INCOMETER with INCOWIN
19