Transcript
尺寸:124*80MM Specification Introduction Congratulations on your purchase of this super-speed USB3.0 Portable Device Disk extrnal enclsoure. This super-speed USB3.0 Device is your USB 3.0 Transfer interface USB3.0 enclosures. Computer will quickly detact and configure the disk without Transfer rata 5Gbps(MAX) restarting when connected with the enclsoure thru USB cable. You can do Support HDD 2.5”/3.5” Hard disk everything u like as using a disk driver.Since it can support large capacity, Work temperature -40 ~ 65 ℃ u can also play Mp3 FILES,run program applicarion and play vidos directly Work humidity 8% ~ 90% ftom disk, and the enclsoure is so light and compact that u can carry it with Storage humidity 5% ~ 95% u anywhere.It is so easy to install that u can actually use it as your Backup Operate system WindowsSE/ME/2000/XP/VISTA/7, Mac friendly, secure and lightweigh removeable mass storage device disk device or replace the ZIP drivers or MO drivers. Please read the manual OS 8.6 or above carefully before use this product. 2 1 System Requirements Hardware:your computer should have USB port Installation 1.Open the box and take out the PCB and chassis 2.Install the hard-disc onto the chassis Software:WindowsSE/ME/2000/XP/VISTA/7,MAC OS 8.6 or 3.Use the screws tighten the hard disk onto the chassis higher version. 4.Put the chassis with hard-disc back into the box, tighten the screws 5.Connect AC power to external case 6.Turn on the switch to “ON” 7.Connect cable to USB port of computer 3 Installation Installation of WindowsSE/ME/2000/XP/VISTA/7 Operation System No driver program is necessary.Connect the USB cable to PC. 4 USER MANUAL HDD EXTERNAL ENCOSURE Click ”My computer” and hard-disc will appear.An icon for online plug should appear on the lower right corner of the status bar ( new hard-disc should be divided into sections with FDISK first, then its icon will appear and normal operation can start after formatting.) 5 Please strongly recommend reading the MANUAL before using the product!