Download TPS Telephone Interface Manual
Transcript
DT-TPS Telephone Interface 2-wire series User Manual www.intelligenthomeonline.com 1 About TPS Telephone Interface The TPS Telephone Interface is designed for 2-wire series video door entry systems. Enables to divert calls from Door Station to a land line telephone or a mobile via landline. Requires connection to a landline. Features: • Maximum 3 telephone numbers can be programmed • Only monitors with ‘Call Divert’ function are compatible • One only TPS Telephone Interface is needed per either house or apartments system • Application: House and Apartments systems 1. Terminals Introduction 1 2 3 4 5 6 ON DIP DIP: 485 PORT: BUS(IN): BUS(OUT): TEL: PBX: 485 PORT BUS(IN) BUS(OUT) DIP switches 485 connection port for updating the software Input port, connect to power supply Output port,connect to Monitor Connect Green&Red from the telephone cable Connect Black&Yellow from the telephone cable TEL PBX 2 Con guration LED BUTTON Power Network Reset Signal Quality Status Transfer Recover Test LED Indicators LED indicator Power Description -LED off - TPS not working -LEDflashesrapidly- systemerror -Steady on - TPS works normally Network Status -Steady on - TPS works normally -LED flashes ones - system receives the effective instruction -LED off - there is no call divert -LEDflashesslowly- TPSinthedivert awaitingstate Transfer -LEDflashes3timesrapidly- divert has failed - Steady on - the system in the talking state *LEDflashesones- all settingsarebeingrestoredto adefault 3 Buttons Operating Button Reset Signal Quality Recover Test Description - Press ‘Reset’ button for 3 seconds, it will restart the TPS - Reserved - Press for 3 seconds for factory default - Reserved 2. Mounting Step1: Mount the din rail to the wall with screws Step2: Pull down the mounting buckle, then hang the unit on din rail Din rail Din rail Mounting Buckle 4 3. DIP Switches Settings for TPS DIP DIP1 DIP2 DIP State Description 1 2 3 4 5 6 Not in use 1 2 3 4 5 6 Set Off - no connection ON 1 2 3 4 5 6 Set On - connected to a telephone network directly ON DIP3 1 2 3 4 5 6 ON Door Station speaker adjustment—set Off for default volume Door Station speaker adjustment—set On to increase the volume 1 2 3 4 5 6 ON DIP4 3 4 5 6 1 2 3 4 5 6 1 2 3 4 5 6 Reserved 1 2 3 4 5 6 Set Off for House system 1 2 3 4 5 6 Set On for Apartment system Door station micphone adjustment—set On to increase the volume ON DIP5 DIP6 Door station micphone adjustment—set Off for default volume 1 2 ON ON ON ON Notes: DIP1 and DIP2 cannot be On at the same time DIP3 and DIP4 cannot be On at the same time 5 4.Telephone Numbers Settings on Monitor Touch screen monitors: -Telephone Number- 1 2 3 1> _ 4 5 6 2> _ 7 8 9 3> _ 0 Don’t divert calls Divert if not answered Divert simultaneously • Maximum 3 telephone numbers can be programmed • Touch the telephone number frame • Using the keypad, type in your number and save it Exit&save Exit&Unsave Button operation monitors: TPS configure 1) 0 2) 3) • Maximum 3 telephone numbers can be set. Use ▲ /▼ Button to move up/down. Press the MENU button to edit. Use▲/▼buttonto increase/ decrease the value 4)Divert mode select: 2 0:Not 1:Not Answer 2:Simulateously Cancel Edit Save&Exit Divert Modes There are 3 types of divert modes • 1 - Do not divert calls. Calls from door station wan’t be diverted • 2 - Divert if not answered. If video monitor was not answered the call within 25 seconds, the call will be diverted to the telephone number you set. In this mode, monitor will shut down when TPS diverts successfully. The monitor still can do the operation of monitoring, talking and unlocking • 3 - Calls from the door station will be diverted to your first telephone number immediately. In this mode, the monitor will rings with video, telephone will ring as well. If monitor answers the call, TPS will stop diverting and telephone will stop ringing 6 5.Operation Instructions Description Function Unlocking • Input 1# on your telephone or mobile phone to releasethefirstlock • Input 2# on you telephone or mobile phone to release the second lock Hanging up • Input 9# on your telephone or mobile phone to hang up. Maximum time untill disconnection is 5 minutes Calling next telephone number • 1:Second telephone number must be programmed on monitor • 2:If first number on the list did not answer the call, TPS will dial next number Calling extention • Add a letter “P” between main telephone number and extention telephone number and TPS will call the extention telephone 6. Connection to a telephone line Use ready made 4-way BT cable or make your own. The end with BT Telephone Male plug should be plugged into telephone socket. Connection to a terminal on TPS Telephone Interface as shown below: 7 Wiring Daisy chain wiring mode for Houses ON CALL UNLOCK TALK/MON IN-USE 1 2 3 4 5 6 Code=14, DIP-6=off ON CALL UNLOCK TALK/MON IN-USE 1 2 3 4 5 6 Code=13, DIP-6=off ON CALL UNLOCK TALK/MON IN-USE 1 2 3 4 5 6 Code=0, DIP-6=off DPS TPS PS4 AC~ 1 23 4 5 6 ON DIP2=On DIP6=Off 8 Star wiring mode for Houses ON CALL UNLOCK TALK/MON IN-USE IN-USE 1 2 3 4 5 6 Code=13, DIP-6=on A B C D Code=14, DIP-6=on ON ON IN-USE 1 2 3 4 5 6 UNLOCK TALK/MON IN-USE 1 2 3 4 5 6 Code=11, DIP-6=on CALL UNLOCK TALK/MON CALL ON UNLOCK TALK/MON IN-USE IN-USE 1 2 3 4 5 6 Code=3, DIP-6=on Code=2, DIP-6=on Impedance switch A B C D 1 2 3 4 5 6 CALL UNLOCK TALK/MON CALL ON UNLOCK TALK/MON IN-USE IN-USE 1 2 3 4 5 6 Code=1, DIP-6=on DIP2=On DIP6=Off 1 2 3 4 5 6 Code=0, DIP-6=on 1 23 4 5 6 ON DPS TPS PS5 85~260AC OFF ON DBC4A Code=12, DIP-6=on ON OFF ON CALL CALL UNLOCK TALK/MON ON Impedance switch CALL UNLOCK TALK/MON DBC4A ON 1 2 3 4 5 6 9 Daisy chain wiring mode for Apartments ON CALL UNLOCK TALK/MON IN-USE 1 2 3 4 5 6 Code=32, DIP-6=on ON CALL UNLOCK TALK/MON IN-USE 1 2 3 4 5 6 Code=30, DIP-6=off DIP2=On DIP6=On ON CALL UNLOCK TALK/MON IN-USE 1 23 4 5 6 ON 1 2 3 4 5 6 Code=1, DIP-6=off TPS DPS PS5 85~260AC 8 Star wiring mode for Apartments ON CALL ON Impedance switch CALL UNLOCK UNLOCK TALK/MON OFF ON TALK/MON IN-USE IN-USE ON A B C D Code=31, DIP-6=on ON CALL DBC4A 1 2 3 4 5 6 1 2 3 4 5 6 Code=32, DIP-6=on CALL UNLOCK TALK/MON UNLOCK TALK/MON IN-USE IN-USE 1 2 3 4 5 6 1 2 3 4 5 6 Code=29, DIP-6=on ON Impedance switch ON CALL CALL UNLOCK UNLOCK TALK/MON TALK/MON IN-USE 1 2 3 4 5 6 IN-USE 1 2 3 4 5 6 Code=4, DIP-6=on A B C D Code=3, DIP-6=on ON ON CALL CALL UNLOCK TALK/MON UNLOCK TALK/MON IN-USE 1 2 3 4 5 6 Code=2, DIP-6=on IN-USE 1 2 3 4 5 6 DIP2=On DIP6=On Code=1, DIP-6=on 1 23 4 5 6 ON DPS TPS PS5 85~260AC OFF ON DBC4A Code=30, DIP-6=on 7.Specification Power input: Power Consumption: Working temperature: Wiring: Dimensions: DC 20~28V Standby(26V):30mA;working(26V):80mA -10ºC +40ºC 2 wire, no-polarity H90 x W72 x D60mm mm 90 mm 72 60 mm The design and specifications can be changed without notice to the user. Right to interpret and copyright of this manual are preserved www.intelligenthomeonline.com