Download TP 277, OP 277 (WinCC flexible) - Service, Support

Transcript
7
Commissioning a Project
7.1
7.1
Overview
Configuration and Process Control Phase
HMI devices can be used to operate and monitor tasks in process and production
automation. The plant screens on the HMI devices are used to provide a clearer overview of
active processes. The HMI device project, which includes the plant screens, is created
during the configuration phase.
Once the project is transferred to the HMI device, current processes can be operated and
monitored in the process control phase. The HMI device is connected to a PLC in the plant
and exchanges values with this PLC.
&RQILJXUDWLRQSKDVH
&RQILJXUDWLRQ3&
&UHDWHSURMHFW
7HVWWKHSURMHFW
6LPXODWHWKHSURMHFW
+0,GHYLFHGHSHQGHQW
6DYHWKHSURMHFW
7UDQVIHUWKHSURMHFW
3URFHVVFRQWUROSKDVH
+0,GHYLFH
2SHUDWHWKHSURMHFW
&RQQHFWLRQWRWKH3/&
3/&
Figure 7-1
Configuration and process control phases
Transferring the Project to the HMI Device
You can transfer a project to an HMI device as follows:
• Transfer the project from the configuration computer
• Restore the project from a PC using ProSave
In this case, an archived project is transferred from a PC to the HMI device. The
configuration software need not be installed on this PC.
TP 277, OP 277 (WinCC flexible)
Operating Instructions, 09/2007, 6AV6691-1DH01-0AB0
7-1