Download TP 277, OP 277 (WinCC flexible) - Service, Support

Transcript
Operating a Project
8.8 Operating Slider Controls
Procedure with Keyboard Operation
Proceed as follows:
1. Select the desired switch within the screen with
2. Press
ENTER
TAB
.
.
Result
The switch changes its appearance. The associated value is switched.
8.8
8.8
Operating Slider Controls
Introduction
The slider control can be used to monitor and change process values within a defined range.
The slider control can also be configured without a slider. In this case, you cannot enter a
value. The slider control is then only used for displaying values.
Figure 8-7
Slider control – example
①
Slider control for entering values
②
Value display with current value
Layout
The layout of the slider control depends on the configuration.
• The slider control can contain a label and a setting range, for example.
• The current value can be displayed below the area of the slider control.
8-22
TP 277, OP 277 (WinCC flexible)
Operating Instructions, 09/2007, 6AV6691-1DH01-0AB0