Download TP 277, OP 277 (WinCC flexible) - Service, Support

Transcript
Operating a Project
8.8 Operating Slider Controls
Procedure with Touch Operation
Proceed as follows:
1. Touch the slider of the desired slide control.
2. Move the slider to the required value.
If a value display has been configured, you can check the exact value that has been set.
3. Release the slider.
Keyboard Control
The table below shows the control keys used to set the slide to a desired value:
Shortcut key
Description
SHIFT
+
or
SHIFT
+
SHIFT
+
or
SHIFT
+
Increase value by 1
Reduce value by 1
Increase value in 5% increments.
HOME
Decrease value in 5% increments.
END
Set maximum value
FN
+
HOME
FN
+
END
Set minimum value
Procedure with Keyboard Operation
Proceed as follows:
1. Select the desired slider control within the screen with
TAB
.
2. Set the slider to the required value.
If a value display has been configured, you can check the exact value that has been set.
Result
The set value is applied.
TP 277, OP 277 (WinCC flexible)
Operating Instructions, 09/2007, 6AV6691-1DH01-0AB0
8-23