• • • • • – Event Mode Interrupt generates an interrupt when any input bit changes – Match Mode Interrupt generates an interrupt when input bits match a preset value – External Strobe Mode latches 8 data inputs and generates and interrupt – Two Strobes can be configured as readable inputs Four USB 2.0 (Universal Serial Bus) Ports – Supports 480 Mb/s (high-speed), 12Mb/s (full-speed), and 1.5Mbs (low speed) peripherals – 500 mA @ 5 Vdc provided per port – USB Boot capability UltraDMA-100 / 66 / 33 Master Mode PCI EIDE Controller – Transfer rate up to 100MB/sec using UltraDMA – Increased reliability using UltraDMA-66 transfer protocols – Support ATAPI compliant devices including DVD drives – 48-bit LBA support for hard drives up to 2.2 terabytes. 32 pin ATA/IDE Disk Chip Socket – Miniature ATA/IDE Flash Disk Chip – Capacities up to 4GB1 – Natively supported by all major operating systems Utility port – PC/AT compatible keyboard port – PS/2 Mouse Port – Speaker port (0.1W output) – Hardware Reset input – Battery input for Real Time Clock – Soft Power Button input Power I/O – Access to PCI-104 and PC/104 Bus pins – Power ground, ±12, 5 & 3.3 VDC BIOS • • • • RTD Enhanced AMI BIOS User-configurable using built-in Setup program Nonvolatile storage of CMOS settings without battery Boot Devices – Standard Devices (floppy disk, hard disk, etc.) – ATA/IDE Disk Chip – USB Device – Network – Fail Safe Boot ROM • • 1. 8 Surface-mount Flash chip that holds ROM-DOS™ Quick Boot mode During the time of this manual’s publication, 4GB was the largest available ATA/IDE Disk Chip capacity CMA157886 cpuModule BDM-610000063 Rev F