Download User manual
Transcript
User manual 1. Remove the transport locking device. 2. Remove the transformer from the supplied packaging and Install this with the 4 screws at the marked Put. 3. Loosen left and right screws and the black align the bracket. 4. Tighten your bottom on the wire and the spring clip located ends eyelets. That the transformer Pay attention not sure is connected to the mains. 5. Now connect the transformer to the plug-in connection with the Ironing. .6. By pressing the red button you heat the wire to Schneider of Styrofoam. 7. Safety note: Please only switch wire when the Unplugged. 8. Replacement wires can be ordered from: www.df-shopping.de or call us at 02871-2422404 Please pull the spring of tension and then attach the wire at the other end.