Download MIL-STD-461F Test Kit 399295 - ETS
Transcript
MIL-STD-461F Test Kit Safety Information The ETS-Lindgren MIL-STD-461F Test Kit is for use with the Model 3301C Active Monopole Antenna, and complies with the MIL-STD-461F standard. For complete safety information, see the Model 3301C user manual. The MIL-STD-461F test kit includes these parts (kit shown assembled): ONLY QUALIFIED PERSONNEL should install, operate, or service this equipment. WARRANTY CONTACT ETS-LINDGREN PRIOR TO SERVICING. Servicing (or modifying) the unit by yourself may void your warranty. If you attempt to service the unit by yourself, disconnect all electrical power before starting. There are voltages at many points in the instrument that could, if contacted, cause personal injury. Only trained service personnel should perform adjustments and/or service procedures upon this instrument. Capacitors inside this instrument may still be CHARGED even when instrument is disconnected from its power source. Cable (27 in) with BNC connector Warranty Information For warranty information, see the Model 3301C user manual. Ferrite bead USA Headquarters 1301 Arrow Point Drive Cedar Park, TX 78613 Phone: (512) 531-6400 [email protected] BNC bulkhead connector Please see www.ets-lindgren.com for a list of all ETS-Lindgren offices. Right-angle bracket © Copyright 2008–2011 by ETS-Lindgren L.P. All Rights Reserved. No part of this document may be copied by any means without written permission from ETS-Lindgren L.P. Note: ETS-Lindgren may substitute a similar part or new part number with the same functionality for another part/part number. Contact ETS-Lindgren for questions about part numbers and ordering parts. The ETS-Lindgren logo is a trademark of ETS-Lindgren L.P. 399295, Rev C Revision/Date: A, Initial Release - September, 2008 B, Update front panel - August, 2009 | C, Add monopole info - July, 2011 www.ets-lindgren.com www.ets-lindgren.com MIL-STD-461F Test Kit Before assembling, read Safety Information on the back page of this document. Assembly Instructions Top of monopole For information on the monopole rod element, see the Model 3301C user manual. 1. Disconnect the Model 3301C from power. 2. Attach the ferrite bead at the midpoint of the BNC cable. Monopole centerline 41.0 in (1040 mm) 3. Attach the angle bracket to the ground plane (screws not included). Counterpoise 47.2 in (1200 mm) Attach ferrite bead at cable midpoint Ground plane Bottom of antenna base Tripod (or other) support not included Connect BNC cable to OUTPUT 4. Plug the BNC cable into OUTPUT on the Model 3301C. 23.6 in (600 mm) 5. Plug the other end of the BNC cable into the BNC bulkhead connector in the right-angle bracket. Ground plane www.ets-lindgren.com