Download SOLAR 20 LED SHED LIGHT - Northern Tool + Equipment
Transcript
SOLAR 20 LED SHED LIGHT User’s Manual Introduction Thank you for purchasing the Sunforce Products Solar Shed Light. Used carefully and in accordance with the instructions set out below, Solar Shed Light should give you many years of trouble free use. Please read the instructions carefully prior to usage. Features: • • • • • • • • Small and compact design Easy to install Dual Settings Bright 20 LED’s - Dim: 10 LED’s (energy saving) 3X Ni-Cd AA 800 mAh 1.2 Volt rechargeable batteries Weather proof solar panel Equipped with 20 ultra bright LED’s Includes three rechargeable batteries Manual ON/OFF override switch. Location SOLAR Collector: 1) For the best result, please locate your solar panel in a position where it receives direct sunlight and is generally free from cover and shade. Be aware of foliage and building overhangs, when placing the Solar Collector. For best results please, allow the Solar Collector, to receive sun for 48 hours, as an initial set-up. Assembly Instructions: Wall mount 1. Carefully remove the Solar Shed Light and all the fittings from the shipping box 2. The Solar Light can be mounted with screws. Measure the distance between screw holes located on the back plate. Mark the area and place screws to the appropriate location. Secure the Solar Light to pre-drilled screws. Operation 1. For daily / normal operation, pull the ON/OFF cord down once to illuminate. 2. Slide the switch the right to illuminate all 20 LED’s and left for the power saving 10 LED position. 3. The red LED will illuminate when the solar collector is connected and charring the internal batteries. Replacing the Batteries For best results, batteries should be replaced every 12 months. Battery charging performance will vary with the time of year, and access to sun 1. Take off the battery compartment cover. 2. Remove old batteies noting orientation of terminals. 3. Install the new batteries in to the battery compartment, ensuring correct polarity 4. Replace battery compartment cover. Trouble Shooting 1) Ensure the Solar Collector is free from shade, during the day 2) Check that the batteries are installed correctly and charged. Maintenance Clean the solar collector regularly with a damp cloth to guarantee optimum performance. Do not use any type of solvent for cleaning and be careful or abrasive surface. Warranty This product is covered by a 1 year limited warranty. Sunforce Products Inc warrants to the original purchaser that this product is free from defects in materials and workmanship for the period of one year from date of purchase. To obtain warranty service please contact Sunforce Products for further instruction, at 1-888-478-6435 or email [email protected]. Proof of purchase including date, and an explanation of complaint is required for warranty service. For more information or technical support 1-888-478-6435 www.sunforceproducts.com [email protected] MADE IN CHINA