Download IRDW-1018ZA6-00D-1B User Manual
Transcript
IRDW-1018ZA6-00D-1B User Manual Please read this manual carefully before using the fixture and keep it for your future reference. Technical Specification: Note: 1. Voltage: AC120V/60HZ 230V/50HZ Caustic or deliquescent chemical can cause damage to the housing. 2. Power consumption: 26W The operation temperature must be below 40℃,humidity is 0~95%. If it is 3.Fuse:2A/125V 1A/250V used out of this range, the lifespan of the fixture will be shortened. 4.Light Source:18pcs1W Purple LED 5.Size:L1004*W78*H158mm For Indoor Use 6.Net weight:4.05KG Warning: Be sure that the input voltage is the same as the rating voltage; deviation below 10% is allowed. The fixture must be linked to the earth wire. Do not dismantle the fixture, if there is any problem with the fixture, please ask professional staff to repair. Dimension: (unit mm) Packaging list: z IRDW-1018ZA6-00D-1B 1M LED purple light---------------------------------------------------------------------------------------------1 台 z User manual -------------------------------------------------------------------------------------------------------------------------------------1 份 1/2 Instruction: IRDW-1018ZA6-00D-1B is a LED washer which is made of 18pcs 1W Purple LED, it is used for replacement of traditional purple light ,this product is easy operation and easy installation, with a low price and well effect, especially suitable for the wash of Home Party and Entertainment place. Back view: ①Power Switch ②Fuse set ③ Power Wire Installation Specification: This fixture can be used on the flat surface or hanging on the wall or ceiling. If you want to hang it, please be sure that you have fixed the screw on the wall or ceiling very closely to avoid any problems. a) Flat surface installation b) Hanging installation Trouble Shooting: Problems The machine does not work LED dimmed Check list 1. If your power is the same as the input of the machine. 2. If the fuse is broken. If your power is the same as the input of the machine. Trouble Shooting 1. Make sure the voltage. 2. Replace the same fuse. Make sure the voltage input. 2/2