Transcript
UCX ™ LED UN D E R C A B I N E T L I G H T Assembly Instructions (US/Canada) The undercabinet light can be mounted on a wood or steel surface. Steel surface Wood surface Secure the mounts to the surface using provided screws. Snap-fit the light to the mounts. Snap-fit the mounts to the groove on the back of the light. Attach to a steel surface. OR After the light is mounted, plug the power supply into the large socket at either end of the light. e od m Optional: Plug a daisy-chain cable* into the other end to power additional units. (Requires a power supply of sufficient power output.) Plug in an occupancy sensor* into the small socket at either end to automatically shut off the light(s) when not in use. (Occupancy sensor only works with UCX units in GROUP mode) Slide your finger along the touchstrip to control brightness/on/off. power supply cable occupancy sensor* • turns off lights if no motion is detected for 15 minutes • resumes last brightness setting when motion is detected LED signal lights indicate whether the light is in GROUP or SINGLE mode daisy-chain cable* Touch and hold the MODE button to switch between GROUP or SINGLE mode *optional GROUP mode: Sync’ed brightness levels with all connected UCX’s. Controllable by occupancy sensor. SINGLE mode: Independent of any connected UCX’s or sensors.