Transcript
! W NE LED Build-a-Sign User Manual Each piece includes the following items: - 1 letter/digit - 2 U-shaped clips - 1 wire cable Step 1: Line up pieces horizontally, vertically, or in both directions and remove the cover from each piece. Up to 35 pieces can be powered from one power supply. 1 Step 2: Physically connect pieces together using U-shaped clips, two clips per side. Press down on clip until it clicks; you may need to press hard. 2 Options include hanging chains, hooks, and a flash module with speed control (0.3 to 3 flashes per second). Step 3: Electrically connect pieces together using wire cable(s) (a). Push excess cable down between pieces (b). Connect power supply to any open connection on any piece (c). Do the same to optional flash module if used. 3a Step 4: Install hanging hooks and chains to completed unit (a). Use 2 chains for every 10 pieces. Replace covers and connect to power source (b). 3b 3c 4a 4b Step 5: On number pieces one can change the number displayed by pressing the A button when power has been applied to the sign. Moving switch B turns the decial point on and off. 5 A B Copyright © 2008 Holiday Technologies. All rights reserved. Call 913.626.6226, e-mail [email protected], or visit www.holidaytechnologies.com for pricing and additional information.