Transcript
KwikLoadeR™ Trimmer Head Stop the Frustration! Quick Loading Head Saves Time and Hassle • Fast, trouble-free loading every time. Reintroducing • Push in trimmer line and go in just seconds. • Accommodates many different trimmer line shapes offered today. • Diamond-shaped eyelet is ideal for OREGON® Flexiblade™ or square trimmer line. Eyelet orients line’s cutting edge in the direction of the cut. • No more tangled spools or winding in the wrong direction. Easy to Load & Remove Trimmer Line • Uses 8" pre-cut line, .095" to .155" diameter. Simply insert to load. • Fits most straight-shaft trimmers (additional adapters required for some curved-shaft models). eyelet Accommodates diverse selection of shaped lines. Just pull to remove. Durable eyelets and flanges enhance line life. Part #55-406-0 WARNING: Serious injury can occur if this trimmer head is not installed and used according to instructions in the operator’s manual for your trimmer. Injury to operators and bystanders can occur from the rotating head or flying debris. Wear eye, face, body and leg protection. Keep bystanders at least 50 ft (15 m) away. Do not operate without cutting shield in place. AVERTISSEMENT : De graves blessures peuvent survenir si cette tête de coupe-bordures n’est pas installée ni utilisée conformément au guide d’utilisation du coupe-bordures. La tête rotative et les débris projetés peuvent entraîner des blessures aux opérateurs et aux personnes à proximité. Se protéger les yeux, le visage, le corps et les jambes. Garder les autres personnes à une distance d’au moins 50 pi. (15 m). Ne jamais utiliser lorsque le protecteur contre les pièces coupantes n’est pas installé. ADVERTENCIA: Se pueden producir lesiones graves si esta cabeza de corte no se instala y se utiliza de acuerdo con las instrucciones del manual del operador de la podadora. Los operadores y las personas en las cercanías pueden sufrir lesiones producidas por la cabeza giratoria o por la expulsión de desechos. Utilice protección para los ojos, la cara, el cuerpo y las piernas. Mantenga alejadas a las personas a una distancia mínima de 50 pies (15 metros). Nunca haga funcionar la unidad sin tener correctamente instalado el escudo protector de la pieza cortante. OREGON® and Jet-Fit® are registered trademarks of Blount, Inc. All other marks are property of their respective owners. For more information on these and other Oregon® products, contact your authorized Oregon® distributor, or: OREGON® | BLOUNT, INC. PO Box 22127 · Portland, OR, U.S.A. 97269-2127 Phone: 800-223-5168 Fax: 503-653-4201 Web: oregonproducts.com OREGON DISTRIBUTION LTD. 505 Edinburgh Rd. N., Guelph, Ontario, Canada N1H 6L4 Phone: 519-822-6870 Fax: 519-822-4999 OREGON® • Blount Inc. • oregonproducts.com KwikLoader™ Head A107018 AC 0412
