Download MyPurMist User Manual 2012-12-28

Cleaning and storage
For your safety
1. If you do not plan to use the device for a long time, empty the
reservoir before storing.
2. If MyPurMist has been in storage for an extended period of
time, fill the water reservoir with MyPurFill and let the device
run for 5 minutes to prevent any odor.
3. MyPurMist patented technology will not transmit germs in
the mist that you breathe. However, periodically you may clean
the outside of the device with soap and water. Make sure the
device is unplugged while cleaning the outside.
4. Do not put the device in a dishwasher or immerse in water.
Do not use abrasives to clean the device.
5. You may periodically remove the mask from the device and
clean with soapy water.
When using electrical appliances, basic safety precautions
should always be followed, including the following:
Troubleshooting
There are no user serviceable parts inside the device. If
MyPurMist is not functioning properly consult the troubleshooting guide available on www.mypurmist.com
One year limited warranty
MyPurMist comes with a limited warranty against defective
material or workmanship for a period of one year from the date
of purchase. Any defective part will be, at the discretion of the
manufacturer, repaired or replaced at no charge if the device
has not been tampered with and has been used according to
this user manual. Retain your receipt to prove warranty. This
warranty gives you specific legal rights, as well as other rights
that may vary from state to state.
Vapore, Inc.
1130 Burnett Avenue, Ste. P
Concord, CA 94520
U.S.A.
© MyPurMist and MyPurFill are
trademarks owned by Vapore, Inc.
MyPurMist shown with
optional child mask
MyPurMist®
handheld steam inhaler
READ ALL INSTRUCTIONS
- Use MyPurMist (device) only for its intended use as described
in this manual.
- To protect against a risk of electric shock, do not use device if it
is wet or is immersed in water or other liquid. Do not use or
store device where it may fall in water (such as a tub or sink).
- The device should always be turned “OFF” and be silent (see:
How to Use” section) before unplugging from outlet.
- Do not operate device with a damaged cord or if the device
has been dropped or damaged.
- Keep device and cord away from heated surfaces. Position
cord to avoid pulling or tripping. Do not wrap cord tightly
around device.
- Always unplug the device when filling or emptying the
reservoir and when not in use.
- Use MyPurFill Demineralized Water in the device. Do not
operate the device without liquid. Do not overfill. Using any
additives in the water reservoir, any other liquid or water with
minerals will damage the device and will void the warranty.
- Do not use device without the water reservoir cap in place.
- Do not allow children under the age of 7 to operate the
device unsupervised. Hold the device for the child and let
them put their face into the mask in a manner that is comfortable.
- Only use manufacturer supplied facemasks, and water
reservoir cap.
- Do not attempt to fix device yourself. If it needs repair or
replacement, contact the manufacturer.
- Do not use device near anything inflammable.
- During use do not block the air vents on the sides or bottom of
the device such as wrapping the product in a blanket.
- Never insert any object or body part into any opening.
User manual
SPECIAL INSTRUCTIONS
- Polarized Plug: This device has a polarized plug (one blade is
wider than the other). It will only fit into a polarized outlet one
way. If it does not fit your outlet, contact a qualified electrician.
Do not attempt to modify the plug in any way.
- Extension Cords: If an extension cord is absolutely necessary,
use an approved extension cord. Care should be taken to
arrange the cord so that it cannot be pulled or tripped over.
Contact us at [email protected] or visit
www.mypurmist.com for further information.
mypurmist.com | 1-855-MYPURMIST
See back for safety information
How to Use MyPurMist
MyPurFill Demineralized Water
1. Pour MyPurFill Demineralized Water in reservoir and let sit for 30 seconds.
For subsequent uses fill water reservoir before each use. Press the ON button.
2. Attach mask by tilting it forward and catching the lower lip of the mask under the
tab in the warm mist opening [figure 1]. Do not push the mask straight down.
3. Plug the device into a standard wall outlet through the supplied power cord.
4. Press ON/OFF button for instant steam.
5. Use the temperature Up and Down button to vary the temperature between 105°F
to 115°F (one to four blue lights).
Figure 1
6. Use MyPurMist by placing mask
over nose and mouth lightly. Breathe
comfortably through nose or mouth.
7. MyPurMist turns off automatically after 25 minutes of use.
For longer use, refill reservoir with MyPurFill Demineralized
Water and turn the device on again.
8. Each time after the device is turned OFF, the fan will run
for 10 min to dry all the internal parts of the device. Do not
unplug device when the fan is running.
Use MyPurFill
Demineralized Water for
optimal long-lasting
operation of the device.
When to Use MyPurMist
Water
reservoir
Red indicator for “out
of water”
4 blue LED indicators of
temperature level
Temperature selection
(105-115°F)
ON / OFF
1. MyPurMist can be used at anytime and for any length
of time. It is the user’s responsibility to determine when
to use the device and the appropriate length of use.
2. A full water reservoir provides 25 minutes of use.
3. Natural steam is doctor recommended for sinus
congestion, sinusitis, allergies, allergic asthma, common
cold, flu, cough, croup, nosebleeds, dry mouth, snoring
from sinus congestion and sinus headaches. Doctors and
medical institutions recommend use of steam 2-4 times a
day for symptomatic relief. Consult your doctor.
4. MyPurMist can be used at anytime of the day. Using
MyPurMist in the evening or before sleeping will likely
result in a more restful sleep.
5. MyPurMist can be used anywhere at home or office or
while traveling - even overseas (110V to 240V).
Remember to bring MyPurFill demineralized water.
MyPurMist®
handheld steam inhaler
mypurmist.com | 1-855-MYPURMIST
DO NOT use tap water or
bottled drinking water
as these have minerals,
which will damage the
device and void the
warranty.
- We recommend using
MyPurFill demineralized
water, which is available in
convenient smaller bottles. MyPurMist uses only 1.5
oz. of water to generate 25 minutes of very fine
soothing steam – so the cost of using MyPurFill is
less than a penny a minute. However, Distilled water
is a type of purified water that could be appropriate
to use in MyPurMist. Do not use other types of
“purified water”.
Masks
Available masks include one for adults and one
for children.
Contact us
Email:
[email protected]
Web (store):
Toll-free call:
www.mypurmist.com
1-855-MYPURMIST
(1-855-697-8764)