Download Overture DH - Short Base Plate Fixing and Operating Instructions
Transcript
Fixing and Operating Instructions Overture DH - Short Base Plate Diagram Fixing Instructions 1. Rout / drill door. Ø1 0. 2. Cut screws (M5) and spindles (8mm Square) to length if necessary. 21.5 Ø1 2 5 3. Place spindles in position 92 4. Place both handles into position and insert and tighten fixing screws, leaving loose. Supplied with: Supplied with: 1 shafts 108mm 1 shaft 95mm 2 screws M5 85mm long 2 screws M5 75mm long 1 shafts 108mm 2 screws M5 85mm long 2 screws M5 75mm long R9 122 .5 Ø1 0 16 TN8100 & TN8104 (Lever/Lever) .5 Routing / Drilling Detail Page 1 of 3 TN8101 & TN 8105 (Lever/Pad) 5. Fit Euro cylinder and tighten handle fixing screws, do not over tighten. Cleaning Door handles should only be cleaned using warm soapy water and a soft cloth. Do not clean any part with solvents or abrasive substances. Failure to adhere to these instructions invalidates your Titon Product Guarantee. Paint or corrosion not covered by Guarantee. BM484 Iss01 © 2014 Fixing and Operating Instructions Overture DH - Short Base Plate Diagram 10.5 29 21.5 44 120 10.5 122 211.5 92 96 33 56 39 6.8 65 6.8 Lever/Pad Page 2 of 3 BM484 Iss01 © 2014 Fixing and Operating Instructions Overture DH - Short Base Plate Diagram 10.5 122 211.5 92 21.5 44 120 43.5 56 Lever/Lever Page 3 of 3 BM484 Iss01 © 2014