Transcript
ASSEMBLY INSTRUCTIONS: MANCHESTER FACEPLATE & STANDARD MASONRY BOX Assembly Instructions: Figure 1 1.Line up the hinges on the faceplate with the notches on the masonry box and insert the faceplate into the box (Figure 1). 2.Open the faceplate door and insert the mounting bolts through the holes in the faceplate and into the threaded inserts on the masonry box. There are 2 bolts/holes; one on each side (Figure 2). 3.Tighten both bolts with a screwdriver (Figure 3). 4.Apply a thin bead of silicone to the outside seam where the masonry box meets the rear of the faceplate. This bead of silicone should only be applied to the top and two side seams of the assembly. Do not apply to the bottom seam (Figure 4). 5.Let the silicone harden overnight before installing the assembly into your column or pilaster. Figure 2 Match your Manchester® with an optional address plaque or newspaper box. Figure 3 Special order from your retailer today! Figure 4 QualArc, Inc. 11300 Trade Center Dr., Ste. A Rancho Cordova, CA 95742 916-273-1576 Fax 916-635-0228 www.qualarc.com