Download RYVYR V-BAMBU-30DB Installation Guide

INSTALLATION INSTRUCTIONS
BAMBU
TM
VANITY
V-BAMBU-30DB | V-BAMBU-36DB
THANK YOU FOR CHOOSING RYVYR
Please take a few minutes to review this manual before you start installation. If you
encounter any installation problems, please don’t hesitate to contact us. Before you
begin, please observe all local building codes. Unpack the new product and inspect
for damage. Please ensure the finished wall is straight and plumb and the floor is flat
and perpendicular to the finished wall.
SUGGESTED TOOLS AND MATERIALS
10'
Phillips Screwdriver
Level
Drill
Tape Measure
Safety Glasses
ROUGH-IN DIMENSIONS
Model #
V-BAMBU-30DE
V-BAMBU-36DE
Width
x = 30" y= [762mm]
x = 36" y= [914mm]
x" [y mm]
FINISHED
WALL
21 1/2" [546mm]
WALL-MOUNT
BRACKET
24" [610mm]
SUGGESTED HEIGHT:
Undermount Application:
10.0” (254mm)
Vessel Application:
6.0” (152mm)
FLOOR
10.2014
For customer support please visit www.ryvyr.com or call 866.395.8112 weekdays 8:00 to 5:00 EST or fax 866.395.8113 any time
WALL PREPARATION
Notch studs 1-1/2” [38mm]
to provide support for brace
2x6
Brace
Position of Bracket
REMOVE WOOD SUPPORTS
Remove wood supports from the back of vanity
10.2014
For customer support please visit www.ryvyr.com or call 866.395.8112 weekdays 8:00 to 5:00 EST or fax 866.395.8113 any time
INSTALLATION INSTRUCTIONS
• Installation requires 2 people.
• Position the vanity against the finished wall.
• With the screws provided, mount the mounting brackets onto the 2 x 6 brace.
CARE AND CLEANING
• To maintain the beauty of the finish, avoid placing the furniture in direct
sunlight, as sunlight causes fading. Also avoid extreme changes in temperature
by arranging furniture away from radiators, heat and air vents, and air
conditioning units. Avoid placing furniture directly under windows.
• Dust the vanity frequently with a clean, soft, dry, lint-free cloth, as well as polish
it on a regular basis. Clean the surface by rubbing in the direction of the grain.
Avoid using silicone cleaners and waxes.
• Clean up excess water and spills immediately. Use blotting rather than a wiping
motion. Water left over a long period of time will cause white spots in the finish
Please note that some chemicals may damage the finish.
10.2014
For customer support please visit www.ryvyr.com or call 866.395.8112 weekdays 8:00 to 5:00 EST or fax 866.395.8113 any time
ADJUSTMENT
SIDE
2
1
1
2
CAM HEIGHT
TILT
10.2014
For customer support please visit www.ryvyr.com or call 866.395.8112 weekdays 8:00 to 5:00 EST or fax 866.395.8113 any time