Transcript
INSTALLATION INSTRUCTIONS For Model 8769 READ AND SAVE THESE INSTRUCTIONS WA R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R . AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR. HANGING THE FIXTURE (Fig. 1) 1. Shut off the power at the circuit breaker and remove the old fixture, including the mounting hardware. 2. Carefully unpack your new fixture and lay out all the parts on a clear area. Take care not to lose any small parts necessary for installation. 3. Thread the 2 mounting screws (B) into the mounting plate (C) spaced the same distance apart as the holes in the fixture canopy (E). (You can adjust the length of the screws if necessary.) 4. Attach the mounting plate (C) to the outlet box with mounting screws (B) (Size: #8-32*0.78"L) CONNECTING THE WIRES (Fig. 2) 5. Connect the electrical wires as shown in Fig.2.Making sure that all wire connectors are secured. If your outlet box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the circular strap using the green screw provided. COMPLETING THE INSTALLATION (Fig. 1) 6. Align the canopy (E) to the mounting plate (C) and secure with the cap nuts (F) 7. Install the bulbs in accordance with the fixture’s specifications. DO NOT EXCEED THE MAXIMUM WATTAGE RATING! (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!) 8. Align the glass shade (G) to the center stem followed by decorative cover (H) and secure with hex-nut (I) and finial (J). Your installation is now complete. junction box and test the fixture. Return power to the Fig. 2 FIXTURE WIRES Black or Smooth FIXTURE WIRES White or Ribbed HOUSE WIRES Black (Hot) FIXTURE WIRES Bare Copper (Ground) HOUSE WIRES White (Neutral) HOUSE WIRES Green or Bare Copper(Gr ound)