Download Vinotemp RACK-12CT Use and Care Manual
Transcript
ASSEMBLY INSTRUCTIONS CELLAR TRELLIS WINE RACK Step 1: Lay out vertical strips with notches. Step 2: Insert horizontal strips into vertical strips. Step 3: Insert dowels at one end of the rack to hold rack steady. Step 4: Insert dowels at the other end of the rack and insert rest of horizontal strips by bisecting the rack. Insert dowels through center of rack (this keeps strips from coming out of the notches.) Install remaining dowels, working from center of the rack towards the outside. 17631 S.Susana Road | Rancho Dominguez | CA | 90221 | www.vinotemp.com 1.800.777.8466 | Fax: 310.866.3310 ASSEMBLY INSTRUCTIONS CELLAR TRELLIS WINE RACK Step 5: Place vertical strips on dowels. Step 6: Place horizontal strips over vertical strips. Step 7: Place nails in all four corners; tap lightly with hammer. (Do not drive nails around perimeter of rack.) This holds strips in place and holes aligned. Starting at the center of rack, place remainder of nails in holes; tap lightly with hammer. After all nails are in place, start at center of rack and drive in the nails completely. (The reason for starting at the center is that it is easier to remove and replace.) Note: To assemble rack, work on a level, solid surface such as 3/4” pressed board. There may be extra pieces (dowels and nails) left after rack has been assembled. 17631 S.Susana Road | Rancho Dominguez | CA | 90221 | www.vinotemp.com 1.800.777.8466 | Fax: 310.866.3310