Transcript
HAND GRIP RAILS TOOLS REQUIRED: 1/8” Hex wrench INSTALLATION: 1. See Fig. #1 . Position the grip rail so that the holes line-up with the studs on the bath. NOTE: The set screws should face toward the floor. Setscrew Under Grip Rail Setscrew Under Grip Rail Fig. #1 2. See Fig. #2. Push grip rail on studs until it contacts the bath surface and tighten set screw with 1/8” hex wrench. Inside Bath Wall Stud Grip Rail Stud Setscrew Under Grip Rail Setscrew Under Grip Rail Fig. #2 SERVICE PARTS ITEM NO. PART NO. DESCRIPTION 1 77407 Rail 2 52306 Set Screw Specify finish when ordering. 1 2 2 114901-2-AA (A) Copyright 1997 Kohler Co.