Transcript
® Retractable Downdraft Vent System PRODUCT MODEL NUMBERS GZ7930XG GZ7930XH OVERALL DIMENSIONS GZ7936XG GZ7936XH top trim widths 30" vent (76.2 cm) 36" vent (91.4 cm) Electrical: 120-volt, 60-Hz, AC-only, 15 amp electrical supply. Use copper wire only. A timedelay fuse or circuit breaker and separate circuit is recommended. 8-1/4" (21 cm) retractable vent height 1-1/2" (3.8 cm) 4" (10.2 cm) 3/8" (9.5 mm) 27" (68.6 cm) for 30" (76.2 cm) vent 33" (83.8 cm) for 36" (91.4 cm) vent 16" (40.6 cm) 8" (20.3 cm) EXTERIOR-MOUNTED BLOWER MOTOR For use with Model No. KPEC992M [900 cfm (25.5 m3/m)] only 26-1/8" (66.4 cm) 3-1/4"x 10" (8.3 cm x 25.4 cm) 16" (40.6 cm) 5/8" (15.9 mm) 9" (22.9 cm) Diameter 5/8" (15.9 mm) INTERNAL 16" BLOWER (40.6 cm) MOTOR 8" (20,3 cm) 2-1/8” (54 cm) 16" (40.6 cm) 9-3/8" (23.8 cm) CABINET OPENING DIMENSIONS See cooktop manufacturer’s instructions for cooktop cutout depth and width. Maximum length of vent system Vent Use dimensions for vent system cutout location that applies to your installation. 4-1/8"+A (10.5 cm) A = 1/2" (12.7 mm) min. 23-9/16" (59.8 cm) 17-9/16" (44.6 cm) 17-3/16" (43.7 cm) all cutouts shown are for 3-1/4" x 10" (8.3 cm x 25.4 cm) vent system Locate power supply junction box at lower right hand rear corner of cabinet. 3/8" (9.5 mm) Length 6" (15.2 cm) round 35 feet (8.9 m) 3-1/4" x 10" (8.3 cm x 25.4 cm) 35 feet (8.9 m) For best performance, use no more than three 90° elbows. If more than one elbow is used, make sure that there is a minimum of 24" (61 cm) of straight vent between any two elbows. Do Not install two elbows together. It is recommended that you use round vent instead of rectangular vent, especially if elbows are required. If rectangular vent is required, it should be transitioned to 6" (15.2 cm) round vent as soon as possible. Determining the length of system you need: centerline of cooktop cutout To calculate the length of system you need, add the equivalent feet for each vent piece that will be needed. See example for 6" (15.2 cm) round vent system. Vent system cutout dimensions for internal blower models only. Exterior mounted blower systems connect with 10" (25.4 cm) round vent. The cutout locations for this vent system will depend upon your specific installation. Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice. Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Specifications subject to change without notice. Ref. 8284826 Rev. B 10-20-03