Download Toyota 250-3642 User's Manual
Transcript
1994 TOYOTA TRUCK THROTTLE LEVER WITH 4 CYL. ADAPTOR ENGINE PACKAGE 250-3642 1. Remove the throttle the Throttle shaft nut and lock washer from the throttle Lever Bracket. Reinstall the lock washer and hex nut. Start the nut by hand to prevent cross-threading. 2. Install the Snap-in cable. NOTE: shaft. Install NOTE: Do not over tighten. adapter from the cruise control kit onto the cruise control A minimum of 1/8" of the cruise control cable must be exposed past the end of the snap-in adaptor. See Figure 1. Nut & Lockwashel Ass'y 1/4"-20 Adaptor-Throttle ~ Threaded Snap-In Module Cable MUST Extend Past Ada?tor 3. Install the cruise control loosening only the REAR cable bracket on vehicle accelerator accelerator cable nut and inserting between the nut and vehicle accelerator cable bracket. cable bracket by the cable bracket Retighten the accelera- tor cable nut. 4. Install cruise control cable into cable bracket by pushing the snap-in adaptor into the square hole of the cable bracket. Form 2645 6/94 5. Connect cruise control cable to the throttle lever using bead chain and the eyelet connector from the cruise kit. Secure the eyelet connector to the throttle lever using the two plain washers and self-locking adaptor kit. pin provided in the throttle See Figure 2. Figure 6. Insure that the cruise control and allows freedom 2 cable is not holding of movement the throttle without possibility ALL RIGHTS RESERVED open in any way of binding PRINTED IN THE USA or hanging up.