Download Swann PPW-250 User's Manual

Wireless / Wired Security Camera
PPW-250 Easy Setup Guide
A
Easy Set up Components
B
Connecting the receiver to record on a VCR
Back of TV
4
Camera and Stand
Extension Cable
2
Receiver
Power only Cable for
Wireless Connection
Power & BNC
Cable for Wired
Connection
4
1
5
3
Input
Output
1
Video
Inputs
Component
Inputs
Output
Back of VCR
3
Receiver Power
Supply
Camera Power
Supply
BNC to RCA
Adapter
Video Cable
1. Using supplied video cable, connect one end to receiver
C
2. Connect other end of video cable to INPUT on VCR
Connecting the receiver to your TV
4. Connect other end of video cable to INPUT on TV
5. Connect power cable to receiver
Back of
Receiver
Back of TV
4
1
5
D
3
Viewing the camera and recording to VCR
1. Power on the receiver,
Video
Inputs
Connect the video
cable to the back
of the receiver
3. Using another video cable (not supplied) connect to VCR OUTPUT
5
Component
Inputs
Output
Connect one end of the
cable to your TV Input
VCR and TV
2. Using your TV’s remote
control tune your TV to
the correct INPUT*. In our
example above the TV
should be set to INPUT 1
3. Using your VCR’s remote
control tune your VCR to
the LINE 1 INPUT*
4. You should now see
your cameras on the
TV screen. Follow
your manufacturer’s
instructions to
record to your VCR
*Some VCR’s and TV’s will list this as INPUT, A/V, SOURCE, L1, Channel 0 - Consult your manufacturer’s manual for more information
Swann Communications • Toll Free Technical Support: USA - 1-800-627-2799, Australia - 1300 13 8324 • Email: [email protected]
www.swannsecurity.com
.com
SR231-WMX-1R005-060409
Wireless / Wired Security Camera
PPW-250 Easy Setup Guide
G
E
Setting up Wireless or Wired options
F
Wireless Camera Positioning
To Power Supply
Cordless Phones/Mobiles
Cable for wired connection
To DVR/Monitor
OR
Wireless Internet
Some Electronic Devices
Note: Wireless and electronic devices such as these can interfere with camera
transmission if they are within the cameras range.
To Power Supply
Some wireless devices can
be set to different frequencies.
Consult the manufacturer’s
manual for details
Cable for wireless connections only
G
Achieving the highest quality wireless signal
A clear line of sight with little wireless interference
will always give you the strongest picture
Walls and floors can also limit range and image results. Place the receiver in a location that
is relatively close to the camera’s position
If possible turn off or keep
the camera and receiver
away from wireless devices
H
General Installation Notes and Tips
1. Test the camera signal before permanently installing the cameras.
2. Using battery power is only recommended for testing purposes as the cameras do require constant power to operate.
3. IR or night vision will reflect off of glass or windows and overexpose the picture. Try placing cameras in direct line of
sight of your subject.
4. Never aim the camera directly at the sun as this can permanently damage the lens.
5. Never submerge the camera in water. Some shelter is recommended such as an awning or eave.
Swann Communications • Toll Free Technical Support: USA - 1-800-627-2799, 1-877-274-3695, Australia - 1300 13 8324 • Email: [email protected]
www.swannsecurity.com
.com