Download Philips MCD196/79 User's Manual
Transcript
MCD196 Quick Start Guide What’s in the Box? You should find these items upon opening the box. Quic Remove the plastic protective sheet 1 k St art Guid e CLOCK Quick Start Guide Composite Video Cable Remote control with battery 2 User Man ual MW antenna MCD196_98 QUG_Eng FM antenna 1 User Manual 13/2/07, 14:41 1 Connect the speaker cables. 2 Connect the FM and MW antennas. Tip 3 See the User Manual for other TV connection options. Connect the composite video cable to a TV. 4 Connect the power cords of the system and TV. TV A FM antenna MW antenna 3 AM AERIAL 2 Speaker (right) FM AERIAL Speaker VIDEO OUT S-VIDEO VIDEO (left) SUB WOOFER OUT DIGITAL OUT R LINE OUT L RIGHT LEFT A To listen to the sound of this DVD Player through your TV, use the audio cables (white/ red-not supplied) to connect LINE OUT (L/R) jacks of the DVD Player to the corresponding AUDIO IN jacks on the TV. 1 + 1 RSP-134V – SPEAKER 4Ω AUDIO OUT L R 4 B AC power cord B To listen to the sound of your TV through this DVD player, use a cinch cable (not supplied) to connect AUX on the front panel of the DVD player to the corresponding AUDIO OUT jacks on the TV. CLOCK Setting up the TV 1 Press SOURCE (DISC on the remote) to select disc source. 2 Turn on the TV and set it to the correct Video In channel. MCD196_98 QUG_Eng 2 13/2/07, 14:41 Setting the clock 1 M I C RO T H E AT R E M C D 1 9 6 STANDBY-ON In standby mode, press and hold DISPLAY/CLOCK SET on the system. SOURCE DISPLAY/CLOCK SET - DBB 2 VOLUME + SET DSC iR PRESET When the hour digits flash, pressí/ëon the front panel or on the remote to set the hours. AUX TUNING PRESET 3 Press DISPLAY/CLOCK SET again and the minute digits flash. Then press í/ë on the front panel or on the remote to set the minutes. 4 DVD/WMA-MP3-CD COMPATIBLE PULL TO OPEN Press DISPLAY/CLOCK SET again to confirm the time setting. Setting system menu options CLOCK Tip See chapters "Preparations" and "System Menu Options" in the User Manual for detailed descriptions. MCD196_98 QUG_Eng 3 13/2/07, 14:41 Playing a disc 1 Press OPEN•CLOSE 0 to open the disc tray and load in a disc, then press the same button again to close the disc tray. ➜ Make sure the label side of the disc is facing up. 2 Playback will start automatically. If not pressÉÅ. 3 To stop playback, press 9. Programming and tuning to radio stations 1 Press SOURCE (TUNER on the remote) to select tuner source. 2 Press PROG/ANGLE for more than two seconds to program all available stations in order of waveband. 3 Press PRESETí/ë until the desired preset station is displayed. Tip Detailed playback features and additional functions are described in the accompany owner's manual. C Royal Philips Electronics N.V. 2007 All rights reserved. http://www.philips.com MCD196_98 QUG_Eng 4 PDCC-JH/ZC-0708 13/2/07, 14:41