Download Miele F 1471 Vi Specification Sheet

Product and Cut-out Dimensions
F1471Vi
84"
25" m
in.
4"
17 3/
24"
EPTS
ACC M
T
I
N
U
STO
A CU PANEL
NT
FRO
O
18"
83 1/2" - 85 3/8"
W
E
E - 5 foot - 120 Volt - 15 Amp 3-wire molded plug power
supply connects lower left rear.
O - Standard NEMA 5-15 Outlet - locate less than 9" above
finished floor
W - 1/4" flexible water line - tape to floor
1 1/4
"
4 1/8
"
6 5/8" - 8 1/2"
Location Codes
2" - 8 3/8"
9 1/2
"
Notes
• All Installations must be done in accordance with local codes
• Sides of adjoining cabinets should be filled (flush to frame) to
insure proper fit and finish
NOTE: Drawing is not to scale.
SPECIFICATION SHEETS 150209
Product and Cut-out Dimensions
F1471Vi
Dispenser location
Hinge
1/2" - 2 3/8"
42 13/16"
14 1/2"
9 1/16"
Hinge
Centerline
Notes
Notes
• Centerpoint is 43 13/16" with typical 84" installation
• All Installations must be done in accordance with local codes
NOTE: Drawing is not to scale.
SPECIFICATION SHEETS 150209
Front Panel Information
Fully Integrated Model
Custom Panel Installations
These units do not come equipped with a front panel. They are designed to accept a custom door panel supplied by
the cabinet maker. Miele has a unique panel integration system which allows the panels to align with the surrounding
cabinets.
Panel size is determined in the following manner:
Width:
17 3/4" in all cases
Thickness:
Minimum 3/4" outside frame
Miele
Fully Integrated
Freezer
Panel Height = HOC - TKH
HOC = Total height of cabinet or side panel
TKH = Toe-kick height
HOC
Panel Height
Height: Determined using the following calculation:
Note:
Finish back side of panels to insure appearance
Panel may extend above unit. This is not
considered in height calculation
Maximum hinge capacity:
200 Pounds
Maximum panel weight:
134 Pounds
TKH
Panel Notes
If the adjoining cabinets are taller than the height of machine (HOM) - the front panel may be extended accordingly.
Simply maintain the toekick height and extend the panel the needed distance.
Adjoining cabinet
Extended Panel
Machine
NOTE: Drawing is not to scale.
SPECIFICATION SHEETS 150209
Front Panel Information
Hinging Details
90° Door
115° Door
Thickness options
Thickness options
0-1/8"
0-1/8"
0-3/4"
1"
1-1/4"
1-1/2"
1-3/4"
0-3/4"
1"
1-1/4"
1-1/2"
1-3/4"
2"
Cabinet Front
Cabinet Front
1"
Fro
nt P
ane
l
0-3/4"
1-1/2"
1-1/4"
1"
1-1/4"
Front Panel
0-3/4"
1-1/2"
Door Swing
Door Swing
7 1/4"
MAX
20 11/16"
7/16"
NOTE: Additional space needed depending on the thickness
of front panels and handle used.
Freezer units cannot be stop pinned at 90°
NOTE: Additional space needed depending on the thickness
of front panels and handle used.
Freezer units cannot be stop pinned at 90°
NOTE: Drawing is not to scale.
SPECIFICATION SHEETS 150209