Download McIntosh C2300 User's Manual

2A
C2300 Rear Panel Connections
MAIN OUTPUTS
(Balanced) send
signals to a Power
Amplifier
MAIN OUTPUTS
send signals to a
Power Amplifier
CDR, CD, D/A and DVD INPUTS (Balanced) accept high
level program source signals
OUTPUTS 1 and 2 (Balanced) send
signals to Power Amplifiers and
are switched On/Off with the Front
Panel Output 1 and 2 Push-Buttons
or Remote Control Push-Buttons
OUTPUTS 1 and 2 send signals to
Power Amplifiers and are switched
On/Off with the Front Panel Output
1 and 2 Push-Buttons or Remote
Control Push-Buttons
SRVR OUT sends
signals to the input of
a recording device
SRVR, CDR, CD, D/A, DVD and
TUNER INPUTS accept high
level program source signals
GND terminals
accept a ground
wire from a
turntable
Connect the C2300
power cord to a live
AC outlet. Refer to information on the back
panel of your C2300 to
determine the correct
voltage for your unit
Main Fuse holder,
refer to information on
the back panel of your
C2300 to determine
the correct fuse size
and rating
MAIN POWER
CONTROL Output sends a turn-on
signal to a McIntosh
Component when the
C2300 is turned on
POWER CONTROL ACC sends Turn-On signals
to McIntosh Source Components when the C2300
is On.
OUTPUT 2 and OUTPUT 1 send Turn-On signals
to McIntosh Power Amplifier(s) when activated.
POWER CONTROLS ACC, OUTPUT 2 and
OUTPUT 1 may be re-assigned as TRIGGERS
A - C to send Turn-On signals when a desired
Input Source is selected
McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, New York 13903-2699 Phone: 607-723-3512 FAX: 607-724-0549
PASSTHRU Power
Control Input receives
a turn-on signal from
a McIntosh Home
Theater Controller
Part No. 04106100
EXT SENSOR connector permits the
connection of a McIntosh IR Sensor for
remote operation
DATA PORTS send
signals to McIntosh
Source Components
to allow control with
the C2300 Remote
Control
PHONO MM accepts
signals from a Moving Magnet Phono
Cartridge
PHONO MC accepts
the low level signals
from a Moving Coil
Phono Cartridge
2B
C2300 Connection Diagram 3
Note: Refer to the C2300 Owner’s Manual page 9 for additional connection information.
McIntosh A/V Control Center
Connection Legend:
Data Cable*Digital Signal Cable Sensor/Keypad Cable RS232 Cable Power Control Cable* Ground Wire Audio Signal Cable AC Power Cords Video Signal Cable Loudspeaker Cable RF Signal Cable * 2 conductor shielded with 1/8 inch stereo mini phone plug on each end.
McIntosh Power Amplifier (Left Channel) - Main Room
(Partial View)
Connect to AC Outlet
McIntosh Power Amplifier (Right Channel) - Main Room
(Partial View)
Connect to AC Outlet
McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, New York 13903-2699 Phone: 607-723-3512 FAX: 607-724-0549