Download Hunter Engineering Quick Tread Specification Sheet
Transcript
Quick Check Cabinet Mount with Quick Tread Flush Mounted Site Specifications 115/230v, 15 amp* 50/60 Hz 1 phƗ Power Requirements 90-150 PSI (6.2-10.3 bar) Air Supply Req. (IS Units) Approximate Air Consumption 25 SCFM @ 90 PSI (648 Lpm @ 6.2 bar) Substructure Specifications Refer to Form 6905-T Pedestal Location 36 - 96 in. (914 - 2438 mm) from QT1F Product Specifications 3500 lb. (1588 kg) per wheel Max. Wheel Weight 2 to 8 mph (3-13 km/h) Test Entry Speed Shipping Weight Cabinet Mount Quick Check and Flush Mount Quick Tread Installation * Quick Check Cabinet 290 lbs (132 kg) Quick Check Drive Under Sensor 316 lbs (143 kg) Quick Tread 1723 lbs (455 kg) Amperage shown is minimal circuit rating. Ɨ Isolated ground recommended. OVERALL FOOTPRINT 15 ft. RECOMMENDED BAY WIDTH QUICK TREAD COMMUNICATION CABLES (UP TO 75 ft.) DISTANCE OF LONGEST WHEELBASE VEHICLE TO BE TESTED (TYPICAL165 in.) 51 in. WALL TO FRONT WHEEL STOP: TYPICAL 118 in. (SPECIFIED RANGE 126 TO 102 in.) SENSOR HEIGHT: 7 ft. 10 in. 93 in. (7 ft. 9 in.) 4 in. TYPICAL RECOMMENDED BAY LENGTH 28 ft. 10 in. TO 26 ft. 10 in. OPTIONAL PEDESTAL LOCATION Continued on Page 2 For inspection information visit: www.hunter.com/inspection For general inquiries visit: www.hunter.com or call 800 448-6848 For local contact visit: www.hunter.com/company/findrep.cfm Form 6896-T, 05-15a Copyright © 2015, Hunter Engineering Company Quick Check Cabinet Mount with Quick Tread Flush Mounted QUICK CHECK DIMENSIONS 96 in. (8 ft.) 24 1/2 in. 16 1/4 in. 82 in. (7 ft. 10 in.) 82 in. (7 ft. 10 in.) 45 1/4 in. 23 1/2 in. QUICK TREAD DIMENSIONS PEDESTAL 26 in. 36 in. 26 in. 5 in. 14 7/8 in. 51 in. 96 in. (8 ft.) is the maximum distance between the middle of the pedestal and nearest edge of Quick Tread. Any further will reduce max vehicle test entry speed. 34 1/2 in. 5 in. 17 3/8 in. 36 to 96 in. (3 ft. to 8 ft.) 93 in. (7 ft. 9 in.) PIT & CONDUIT SPECIFICATIONS END VIEW SIDE VIEW QUICK TREAD: HUNTER SUPPLIED Quick Tread’s 3 in. underground conduit must be routed to the pedestal according to local codes. The pedestal can be placed on either side. Exact placement of conduit will vary. Refer to Form 6905-T. QUICK TREAD SUB-STRUCTURE: CONTRACTOR SUPPLIED 93 in. 51 in. BAY FLOOR 8 in. 12 in. (min.) 46.25 in. 88 in. Form 6896-T, 05-15a Copyright © 2015, Hunter Engineering Company