Download Human Touch Mobility Scooter Perfect Chair User's Manual
Transcript
June 5, 2009 *PC-085 shown PC-075/085/095 REPLACING THE FOOTREST ROD SERVICE LEVEL: 2 Tools Required: 4 mm (5/32") Allen Key (provided), 10-mm wrench SAVE ALL REMOVED PARTS FOR USE DURING REASSEMBLY (Fig.1) Footrest rod assembled GET READY 1. Gently tip the chair on its back (Fig.1). REMOVING THE FOOTREST ROD 1. Using a 10-mm wrench, turn the metal footrest rod nut counter-clockwise to detach the rod from the spacer barrel, Spacer barrel then remove the rod from the chair frame. 2. Using the 4 mm (5/32") Allen Key (provided), remove the screw from the top of the black plastic spacer barrel to detach the spacer barrel from the bracket (Fig.2). Footrest rod (Fig.2) 1 INSTALLING THE NEW FOOTREST ROD Screw 1. Remove the screw from the top of the black plastic spacer barrel (Fig.3). 2. Align the spacer barrel with the corresponding hole on the bracket, then secure it using the screw Bracket you removed in the previous step and the 4 mm (5/32") Allen Key (Fig.4). 3. From below the chair frame, insert the metal rod through the corresponding hole in the chair Spacer barrel frame then into the black spacer barrel (Fig.4). 4. Turn the metal rod clockwise by hand to secure it, then tighten it using a 10-mm wrench. Footrest rod (Fig.4) (Fig.3) Please send any questions or comments regarding these instructions to: [email protected] © 2009 Human Touch™, LLC. 2