Download Hobart PRIME 873440 User's Manual
Transcript
ASSEMBLY INSTRUCTIONS Adapter — KIT NO. 873440 For Hobart PRIME™ Mixer-Grinders with 15° incline cylinder and Hollymatic model 120 Bulker. PART NO. 873440 873430 873437 F-34483 NAME OF PART AMT. Adapter Kit (complete) .......................................................... Adapter, Bulker ........................................................................ Long Support Rod .................................................................... Assembly Instructions ............................................................. 1 1 1 1 ASSEMBLY WARNING: DISCONNECT ELECTRICAL POWER. PAPER ROLL 1. Remove the paper roll from the Hollymatic Model 120. Pull the pin out of the bracket underneath the bulker. Remove the Bulker from its pedestal by lifting straight up. Carefully set the Hollymatic Model 120 Bulker on its side (Fig. 1). HOLLY BULKER BRACKET PIN PL-41437-1 Fig. 1 2. Unscrew the height adjustment screw and remove the support rod from the pedestal. The long rod from the kit must be used with the Hobart PRIME™ Mixer-Grinder. LONG SUPPORT ROD HEIGHT ADJUSTMENT SCREW 3. Assemble the Long Support Rod from the kit into the pedestal base making sure the grooved part of the Support Rod is up. Re-tighten the height adjustment screw so the support rod is stable, Fig. 2. PEDESTAL BASE PL-41438-1 Fig. 2 701 S. RIDGE AVENUE TROY, OHIO 45374-0001 937 332-3000 www.hobartcorp.com FORM 34483 (May 2000) ASSEMBLY (continued) BRACKET 4. Assemble the Hollymatic model 120 bulker to the Pedestal. To fasten the bulker to its pedestal, insert the pin through the hole in the bracket. The bulker can swivel 360°. Reassemble paper roll (Fig. 3). PIN SUPPORT PAPER ROLL PL-41439-1 Fig. 3 BULKER ADAPTER 5. Assemble the bulker adapter to the bulker input tube using the clamp provided with the Hollymatic Bulker, (Fig. 4). BULKER CLAMP PL-41440-1 Fig. 4 6. Assemble the Tightening Ring shipped with the Hollymatic Bulker to the cylinder of the Hobart Mixer-Grinder (Fig. 5). A second clamp (also sourced from Hollymatic, Fig. 5) must be used to clamp the Bulker Adapter to the Tightening Ring. TIGHTENING RING CLAMP When making the final linkup of the Hollymatic model 120 Bulker to the Hobart Mixer-Grinder, the height of the Bulker may need to be adjusted. The Bulker Adapter can be swiveled to allow the final adjustment before locking the clamps in place. FORM 34483 (May 2000) PL-41441-1 Fig. 5 –2– PRINTED IN U.S.A.