Download GE GSM2260NSS User's Manual

Spacemaker Dishwasher Dimensions
(Pub. 1-G003 pg. 132B) May 12, 1993
GSM2260N
GE Spacemaker Under-the-Sink Dishwasher
®
DW PLUMBING/ELECTRICAL
ROUGH-IN (IN INCHES)
Dimensions and Installation Information (in inches)
Note: Undersink dishwashers can be installed only
under sinks and not under other appliances.
Plumbing—Hot Water Only: Use 3/8" O.D. copper
tubing or 1/2" O.D. plastic tubing minimum inlet
line. Water valve has 3/8" internal threads. Hand
cut-off valve is recommended.
FRONT VIEW
Plumbing and
wiring must enter
within this area
from either side,
4 rear or bottom
Electrical: Fuse circuit with 15 amp or 20 amp
standard fuse or circuit breaker. Total amp load is
8.6. Dishwasher operates on 120V, 60HZ power,
Two-wire cable (14 Ga. Min.) with ground must be
installed.
Specifications: Inlet water temperature
recommended—minimum 120°F at dishwasher.
Inlet water pressure required—15 to 120 lbs./sq.
inch.
Note: All rough-in, both plumbing and electrical,
must be completed before the dishwasher is
installed. All plumbing and electrical work must be
in accordance with local codes.
6
2" From
cabinet
Cold
Hot
19" From
Cable 24"
wall
from wall
2" From
floor
Ground
Black (line)
White (neutral)
3
For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
ge.com or call GE Answer Center® service,
800.626.2000.
Listed by
Underwriters
Laboratories
As an Energy Star®
partner, GE has determined
that this product meets the
Energy Star guidelines
for energy efficiency.
Specification Created 10/07
350512
10"
from
cabinet
GSM2260N
Allow a 5"
radius to
prevent kinking
GE Spacemaker® Under-the-Sink Dishwasher
Note: A close-fitting elbow or special
shallow sink strainer is necessary to
provide clearance between sink drain
and dishwasher. Dishwasher furnished
with 1/2" I.D. drain hose, 78" long. If using
copper tubing, 2" length of 1/2" I.D. rubber
hose must be provided to connect copper
tubing to pump outlet. Disposer should
have 7/8" I.D. dishwasher drain connector.
Rough-In for Installation with Disposer Dimensions
(in inches)
Waste air gap
To
air
gap
Directional flow tee
FRONT VIEW
Drain
connection
4
1-1/2" MAX.
dia. hole
Waste tee
or disposer
Remove hopper plug
before connecting
dishwasher drain
12" From wall
6
10"
from
cabinet
Sink
strainer
assembly
GFC290/300/700
Disposall®
unit
Countertop
25" deep
1-1/2" thick
1-1/2" Close
elbow
1-1/2"
Directional
flow tee
Spacemaker®
dishwasher
Cold water
Hot water
Valve to shut off
water to dishwasher
Dishwasher
water inlet
valve
Electrical
junction box
(on dishwasher)
Allow a 5"
radius to
prevent kinking
Sink
strainer
assembly
GFC290/300/700
Disposall®
unit
Cold water
Hot water
Valve to shut off
water to dishwasher
6" Double-bowl
stainless steel sink
Hot water supply
to dishwasher Dishwasher
drain hose
6" Double-bowl
stainless steel sink
1-1/2"
Directional
flow tee
Rear View Plumbing Arrangement Dimensions
(in inches)
Countertop
25" deep
1-1/2" thick
1-1/2" Close
elbow
Spacemaker®
dishwasher
Hot water supply
to dishwasher Dishwasher
drain hose
Dishwasher
water inlet
valve
Electrical
junction box
(on dishwasher)
Listed by
Underwriters
Laboratories
As an Energy Star®
partner, GE has determined
that this product meets the
Energy Star guidelines
for energy efficiency.
Specification Created 10/07
350512
installer at time of installation.
GSM2260N
GE Spacemaker® Under-the-Sink Dishwasher
Wall
Cabinet Rough-In Dimensions (in inches)
Cabinet Rough-In Note: Either single- or
double-bowl sink may be used, centered
or offset, as shown in the front view
illustration.
The 20-1/2" maximum dimension from wall
to front of sink bowl must be accurate if
dishwasher is to fit properly under sink.
Water lines to sink faucet and drain from
sink can be run through area “A.”
Countertop 1-1/2" MIN. thick
If the sink bowl is more than 20-1/2"
maximum specified distance form the
wall, or if the base cabinet is less than the
24" minimum depth from the wall, a gap
between the tub front flange and the front
of the base cabinet may result.
to
Either single- or double-bowl si
sink flange
shown
in the front view illustrat
10-1/4" MAX.
singleor be
doub
A Plumbing
to front ofEither
sink bowl
must
ac
depth
6"
MAX.
1-1/4"
shown
inlines
the front
vie
under sink.
Water
to sink
10-1/4" MAX.
7-1/2
MIN. I.R.
A Plumbing
to front
sinkWATER
bowl m
depth
through area
“A.”ofHOT
1-1/4"
11-3/4"
under
sink.water
Water
line
7-1/2
Garbage
disposer,
lines
34-1/4
MIN.
I.R.
MAX. Plumbing
through
area “A.”
HOT
cutoff
valve
are
installed
in
12"
± 1/4
Garbage
disposer,
34-1/4Dishwasher MAX.11-3/4"
opening for
garbage
disposerwa
m
Plumbing
C
valve are
install
± 1/4SIDE VIEW
view, areacutoff
“C” (7-1/2").
This
wil
Dishwasher
opening
for
garbage
plumbing in cabinet “C” when ud
Front of cabinet
areaMAX.
“C” (7-1/2"
SIDE VIEW
Toe
more thanview,
20-1/2"
specifD
Flange
cabinet
“C
kick
Front of cabinet
cabinet isplumbing
less thaninthe
24" MIN
(Pub.
1Toe
more than
20-1/2"
MA
area
4" MAX.FlangeB
tub
front
flange
and
the
front
of
kick
cabinet is less than th
B
area
4" MAX.
front flange and th
Dishwashers tub
Installation
Floor
Dishwashers Installation
24"
Floor
(Pub. 1-G003 pg. 131B) May 12, 1993
GE/Hotpoint/RCA
min. cabinet
(Pub. 1-G003 pg. 131B) May 12, 1993
Floor
12"
24"
Floor
MIN.
min. cabinet
Countertop 1-1/2" MIN. thick
10-1/4" MAX.
A
10-1/4" MAX.
A
C
FRONT VIEW
FRONT VIEW
6" MAX.
B
HOT WATER line to dishwasher is installed
in area “B.”
Garbage disposer, water lines to faucet,
trap, waste air gap and water cutoff valve
are installed in 12" wide cabinet shown
in area “C.” Sink opening for garbage
disposer must be dimensioned as shown in
front view, area “C” (7-1/2"). This will provide
clearance for the disposer and plumbing in
cabinet “C” when using double bowl sink.
3/4" MIN.
6" MAX.
B
24
24
12"
MIN.
20-1/2" MAX.
Wall
Sink bowl
1" MAX. to
20-1/2" MAX.
11" MIN
sink
flange
Sink bowl
Drain CL
1" MAX.
3/4" MIN.
11" MIN
6" MAX. Drain CL
Wood Insert Cut-Out Dime
Wood
Wood Insert
Insert Cut-Out
Cut-Out Dimensions
Dimensions (in
(in inches)
inches)
Cabinet Cut-Out for Sink Dimensions (in inches)
GE/Hotpoint/RCA
GE/Hotpoint/RCA
Undersink Dishwasher Wood Insert Dimensions
(in inches)
Door insert
Sink
installation
cutout
Panel Thic
A
3/
8" x 20" Adjacent
cabinet rear cutout
5
Cabinet side
adjacent to D/W
FRONT VIEW
Door
Door insert
insert
18-7/8
Door insert
5
3-1/4
11-3/4
12-1/2
Access
Access insert
insert
3-11/16
Access insert
23-9/16
12
Cabinet cutouts for offset single and double
bowl sinks. Dishwasher not provided with
complete enclosure. Enclosures for sides,
top, bottom and back must be provided by
installer at time of installation.
A
A
Panel
Panel Thickness
Thickness
C
C
B
B
Inserts must not
exceed When
1/4" thickness
using GPF325
When
GPF325
within 5/16"
of using dishwasher
1/4"
custom
1/4" custom
dishwasher
edge around
full
door
door and
and access
access panel
panel kit.
kit.
circumference.
When
using
GPF375
When using GPF375
3/4"
3/4" custom
custom dishwasher
dishwasher
door
door and
and access
access panel
panel kit.
kit.
Front
of
Panel
Listed by
Underwriters
Laboratories
3/4
3/4 insert
Access
Front
Front
of
of
B
Panel
Panel
C
1-1/2
1-1/2
1-1/2 1/2
1/2
When using GPF325
1/4 dishwasher
1/4" custom
1/4
door and access panel kit.
When using GPF375
3/4" custom dishwasher
door and access panel kit.
As an Energy Star®
partner, GE has determined
that this product meets the
Energy Star guidelines
for energy efficiency.
Specification Created 10/07
350512
1/2
GSM2260N
GE Spacemaker® Under-the-Sink Dishwasher
Features and Benefits
• Stainless Steel Door - Brings a polished look to any kitchen
• Spacemaker® Upper Rack - Makes the most of any space, providing a roomy
area for glassware and dishes
• 4-level PowerScrub™ Wash System - Four wash levels quietly and efficiently
scrub dishes clean
• Deluxe Silverware Basket - Provides convenient space and capacity to clean
silverware efficiently and effectively
• QuietPower™ Motor - Runs quietly and efficiently to keep the kitchen peaceful
and quiet
• HotStart™ Option - Preheats water before the main wash cycle for dependable
performance every time
• Meets 2007 ENERGY STAR® Criteria - Can reduce utility bill by using less water
to get dishes clean
• Model GSM2260NSS - Stainless steel
GSM2260NSS
Specification Created 10/07
350512