Download Fellowes S40C User's Manual

®
Powershred
®
Table Top
Paper Shredder
Operating Instructions
Powerhouse 1000
X
Important Safety Instructions
Installation
1. Read all instructions before use.
Unpack your new shredder from its shipping
2. Save these instructions for later use.
container.
3. Follow all warnings and instructions marked on the
Place the shredder on a table top, desk or the
product.
optional shredder stand. Be sure the selected work
4. Unplug this product from the wall outlet before
surface is strong enough to support the weight of
cleaning. Clean with a damp cloth using a mild soap
and water solution. (Do not use abrasives or petroleum the shredder.
based cleaners.)
To attach the wire form feed guide, tilt the shredder
5. Place this product as close as possible to power source
back until the front feet lift off the table. Angle the
for quick and easy unplugging. Do not block the power
wire form feed guide so one “U” curve fits around
supply receptacle; it must be possible to conveniently
one of the metal tabs. Wrap the other side’s “U”
unplug the power cord.
curve around the other metal tab. Set the shredder
6. Do not use this product near water.
down so the front edge of the guide extends one7. This product should never be placed near or over a
half in front of the machine, with the rest of the
radiator or heat source.
8. Operate from the type of power source indicated on
guide between the shredder and the table.
the marking label. If you are not sure of the type of
Holding the bag support rod horizontally, pull the
power available, consult your dealer or local electricity
bag up through the center of the rod and wrap the
board.
edges of the bag over the rod. To attach the rod to
9. Do not allow anything to rest on the power cord. Do
the machine, squeeze the ends of the rod together
not place this product where people may walk on the
enough (approximately 1-1/2”) to fit between the
cord.
back feet on the shredder base. From the back of
10. If an extension cord is used, be sure that all products
plugged into the extension cord do not exceed the
the machine, slide the rod under the shredder until
extension cord ampere rating.
it stops. Release the rod to allow it to snap into
11. Do not attempt to service this product yourself, as
place, with the ends resting against the shredder
opening or removing covers may expose you to
feet. Make sure the bag does not block output from
dangerous live parts or other risks, and will void the
the shredder.
warranty.
When shredding continuous forms, feed paper
12. Unplug this product and refer servicing to qualified
personnel under the following conditions:
between the guide and the shredder into the
A) When the power cord or plug is damaged or
shredder throat.
frayed.
B) If liquid has been spilled on the product.
Parts Identification
C) If the product has been exposed to rain.
D) If the product does not operate normally when the
operating instructions are followed.
E) If the product has been dropped or
the casing has been damaged.
Front
13. Keep out of the reach of children.
14. This shredder should be operated only with an
operator in attendance.
15. Do not insert aerosal cleaners into or around
the shredder. Some agents may combust,
causing serious injury.
Bag Support Rod
Wire Form
Feed Guide
Front Feet
Back Feet
Bag
Caution
Never insert hand, fingers or any
foreign objects into the feed
opening. Serious injury may
result.
Keep all loose articles of clothing,
ties, jewelry, long hair or other
loose objects away from feed
opening. Injury may result.
Always turn off and unplug the
machine before moving, servicing,
cleaning or conducting any activity
other than normal operation.
Serious injury may result.
Operation
Read operating instructions before
putting shredder into
operation.
Insert plug into power outlet.
Switching shredder to REVERSE.
Press rocker switch to position (R)
and hold. The cutting system is
now running in the reverse
direction. Release the switch and
it will automatically reset to (0)
0FF.
If a Jam Occurs
The cutting system may jam if the recommended capacity
is exceeded (see specifications). When this occurs,
depress the switch to the REVERSE position (R). This will
back out the jammed material. The operator should tear
out and remove excess jammed paper, if necessary, and
then commence shredding in smaller quantities so as not
to further jam the machine.
Maintenance
• No adjustments or maintenance inside of machine is
required.
• Periodically, unplug shredder to clean dust and debris
that may accumulate.
• For repairs, call Fellowes Customer Service at 1-800955-0959.
Technical Specifications
Cutting Style
Prepare paper to be shredded, making sure not to
exceed the recommended sheet capacity. Small paper
clips will not harm the cutting system, but the added
thickness may decrease sheet capacity (see
specifications for recommended sheet capacities).
Switching shredder ON/FORWARD.
Press rocker switch to position (I)
(the switch will lock into place.) The
cutting system is now running in the
forward mode. Insert the paper into
throat opening and the cutting
system will pull the paper in.
Switching shredder OFF.
Lightly press rocker switch towards
(R) The switch will reset to the
OFF position (0) and the cutting
system will stop.
Strip
Shred Size
1/4” (5.99mm)
Sheet Capacity
8-1/2 x 11” 20 lb.
16-18
Speed 115V, 60Hz
24 FPM
Entry Width
Motor Power 120V
15” (381mm)
1/4 hp
Input voltage
120V 50/60Hz
(Depending on country) 220-240v/50Hz
Dimensions
Inches
Millimeters
111/2 H x 219/10 W x 17 D
292 H x 556 W x 431 D
Weight
45 lbs. (20.4 kg)
Reorder bag number
36051
Stand
38915
Supplies
• Five complimentary bags are included with your machine.
• Replacement bags are packed 50 to a dispenser carton.
• Contact your local Fellowes dealer to order bags that fit your
machine. Cutting block oil is not needed on this machine.
Warranty
Fellowes Powershred Limited Warranty
1 year on all parts and labor
5 years parts and labor on cutting cylinders
Fellowes warrants this product to be free from defects in
material and workmanship for a period of one year from
the date of purchase by the original consumer. At it’s
option, Fellowes will repair or replace without charge for
material or labor, any component found to be defective
during the warranty period. Additionally, the cutting
cylinders are warranted for 5 years from the original
purchase date and will be replaced without charge for
material or labor if found by Fellowes to be defective.
Warranty Exclusions
1. When this product or any part thereof has been subjected to
accident, alteration, abuse, or misuse.
2. When the shredder's recommended sheet capacity (per
specifications on page 5-6) has been exceeded (resulting in a
paper jam).
3. When the original Model and Serial Number Plate has been
altered, effaced or removed.
4. When repair or service covered under this warranty (other than
routine maintenance as described in the Owner's Manual) has
been performed by personnel without the express written consent
of Fellowes.
5. When the product has been used pursuant to any verbal or
written rental, lease or loan agreement.
This warranty described herein shall
be in lieu of any other warranty,
expressed or implied, including, but
not limited to, any implied warranty of
merchantability or fitness for a
particular purpose. Any
representations or promises
inconsistent with or in addition to this
warranty are unauthorized and shall
not be binding upon Fellowes.
The parties agree that the buyer’s sole and exclusive
remedy against Fellowes shall be for the repair or
replacement of defective parts as provided herein. The
buyer agrees that no other remedy (including, but not
limited to, incidental or consequential damages for lost
profits, lost sales, injury to property or any other incidental
or consequential loss) shall be available to him. This
warranty shall NOT apply and is void under the following
circumstances:
Contact For Service:
United States
Australia
Canada
Japan
Europe
1-800-955-0959
(In Melbourne) (03) 9330-3211
(Outside Melbourne) 1-800-331-177
1-800-665-4339
+81-3-5496-2400
00-800-1810-1810
1789 Norwood Avenue • Itasca, Illinois 60143-1095
630-893-1600 • Customer Service 1-800-955-0959
http://www.fellowes.com
®
Australia
Tullamarine,
Victoria
Benelux
Vianen,
The Netherlands
Canada
Markham,
Ontario
Deutschland
Hanover,
Garbsen
France
Montanay,
Lyon
Italy
Via Dante Alighieri,
Camerano (An)
Japan
Tokyo
United Kingdom
Doncaster,
South Yorkshire
© 2001 Fellowes Printed in U.S.A. Part No. 30067