Transcript
PLEBE ROUND FRONT COMPLETE Toilet VITREOUS CHINA PLEBE ROUND FRONT COMPLETE TOILET ❑ 3500.000 •Vitreous china •Low-consumption (6.0 Lpf/1.6 gpf) •305mm (12") rough-in •Round front bowl •Close-coupled tank •Color matched trip lever •2 bolt caps • Includes color-matched solid plastic seat and cover • Wax ring gasket with closet bolts •100% factory flush tested Nominal Dimensions: 693 x 505 x 752mm (27-5/16" x 19-7/8" x 29-5/8") Compliance Certifications Meets or Exceeds the Following Specifications: • ASME A112.19.2M for Vitreous China Fixtures - includes Flush Performance, Ball PassDiameter, Trap Seal Depth and all Dimensions FINISHED WALL 17mm ± 6mm (11/16 ±1/4) 693mm (27-5/16) 505mm (19-7/8) 232mm (9-1/8) 425mm (16-3/4) To Be Specified: ❏ Color: ❏ White ❏ Bone ❏ Supply with stop: C/L C/L OF SEAT POST HOLES 140mm (5-1/2 CENTERS) 752mm (29-5/8) 84mm (3-5/16) SUPPLY AS REQ'D 383mm (15-1/16) * 203mm (8) 152mm (6) 16mm (5/8) 159mm (6-1/4) 305mm (12) 308mm (11-1/4) 375mm (14-3/4) FINISHED FLOOR 232mm (9-1/8) C/L OF OUTLET NOTES: THIS COMBINATION IS DESIGNED TO ROUGH-IN AT A MINIMUM DIMENSION OF 305MM (12") FROM FINISHED WALL TO C/L OF OUTLET. DIMENSION SHOWN FOR LOCATION OF SUPPLY IS SUGGESTED. *SUPPLY NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED SEPARATELY. FOR ADDITIONAL INFORMATION REFER TO INSTALLATION INSTRUCTIONS SUPPLIED. IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerance established by ANSI Standard A112.19.2 These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided pages. © 2008 AS America Inc. K101 Revised 2/08