Download Brodit ProClip 655026

27 January, 2015, www.brodit.com, © 2015 Brodit AB
Product 655026
655026 ProClip
Angled mount
The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for
your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is
car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required
and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.
EAN: 7320286550260
Item no 655026 fits:
Jeep Cherokee 14-15 (For all countries)
1 (2)
INSTALLATION INSTRUCTIONS
1.
2.
3.
4.
Please read the instructions and look at the pictures before installing the ProClip.
1. Use the enclosed alcohol pad to clean the area where the ProClip is to be installed. Peel of the adhesive tape
cover on the ProClip. Place the ProClip over the area where it will be attached for proper alignment. Place your
finger at the bottom edge to mark the placement.
2. Where your finger is marking the placement, press the lower angled edge of the ProClip into the seam
between the padded upper dash and the lower solid part of the dash. The lower edge of the ProClip will hook
behind the lower dash panel as you rotate the ProClip upward.
3. Rotate the ProClip upward so the angled edge on the lower part hooks behind the lower dashboard panel.
Then pull the upper part of the ProClip upward to hook the angled upper edge of the ProClip over the air vent
edge.
4. The seam between the vent frame and inside of the vent is a tight seam. To make the upper angled edge of
the ProClip go all the way into the seam between the air vent and the surrounding panel frame, pull the ProClip
towards you and press down at the same time. It might need to be wiggled a little. Listen for the click as the
ProClip goes into place.
2 (2)