Transcript
S P E F C I L E ET-PKE16H Ceiling mount bracket for high ceilings D escription This ceiling mount bracket is used when mounting a Panasonic projector to high ceilings. NOTE: This ceiling mount bracket cannot be used by itself. Combine it with the optional ET-PKE16B bracket assembly. Specifications Vertical correction angle: Horizontal slant correction angle: Horizontal turn correction angle: Dimensions (W × H × D): ±10° ±5° ±10° 400 × 909 –1,269 × 400 mm (15-3/4˝ × 35-25/32˝– 49-31/32˝ × 15-3/4 ˝ ) Approx. 17 kg* (37.5 lbs*) ET-PKE16B Weight: Applicable bracket assembly: * Average value. May differ depending on models. Parts Projector mount bracket A Projector mount bracket B Pole joint bolt . . . . . . . . . Washer (M10) . . . . . . . . . (pole included) (pole included) ............. ............. . . . . . . . . . . . . . . . . . . . . 1 1 2 2 Hexagonal nut (M10) . . . . . . . . . . . . . . . . . . . . . 2 Snap pin . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Screws (M5 × 10) . . . . . . . . . . . . . . . . . . . . . . . . 4 Caution: • Mounting should be done by a qualified technician. • Make sure that the mounting (ceiling) area has sufficient strength. • Read the enclosed mounting instructions thoroughly before starting. • Do not use an electric screwdriver or impact driver to tighten screws. Use a torque driver or hexagon torque wrench and tighten screws to the torque specified in the instructions. • When the product is no longer going to be used, have it disposed of quickly by a professional disposal service. 889–1249 (35 – 49-3/16) Adjustable in 60 mm ( 2-3/8 ) steps ∅70 (2-3/4) 5° 10° 5° 1172 –1532 (146-5-32–60-5/16) Adjustable in 60 mm ( 2-3/8 ) steps Dimensions 10° A* 1 25* (31/32)* 650 (25-19/32) * From ce nte r of rot ation to ce nte r of le ns 386.5 (15-7/32) 428.5 (16-7/8) 4 – ∅ 13 ( ∅ 1/ 2 ) Projector 340 (13-3/8) 90 (3-17/32) 10° The illustration shows the ceiling mount bracket when it is combined with the ET-PKE16B and the PT-EX16K is attached. 90 (3-17/32) 10° 40 × 60 (1-9/16 × 2-3/8 ) 90 (3-17/32) 340 (13-3/8) 13 × 20 (1/2 × 25/32) 90 (3-17/32) unit : mm (inch) NOTE: This illustration is not drawn to scale. Weights and dimensions shown are approximate. Specifications subject to change without notice. As of September 2011 SFL11A018 1/1
