Transcript
S P E F C I L E ET-PKV100H Ceiling mount bracket for high ceilings D escription This ceiling mount bracket is used when mounting a Panasonic projector to high ceilings. NOTE: This ceiling mount bracket cannot be used by itself. Combine it with the optional ET-PKV100B bracket assembly. Specifications Vertical correction angle: Horizontal slant correction angle: Horizontal turn correction angle: Dimensions (W × H × D): ±15° ±15° 360° 176 × 830 – 1,400 × 226 mm (6-15/16˝ × 32-11/16˝–55-1/8˝ × 8-29/32˝ ) Approx. 4.1 kg* (9.0 lbs*) ET-PKV100B Weight: Applicable bracket assembly: * Average value. May differ depending on models. Parts Projector mount bracket A Projector mount bracket B Pole joint bolt . . . . . . . . . Washer (M6) . . . . . . . . . . (pole included) (pole included) ............. ............. . . . . . . . . . . . . . . . . . . . . 1 1 1 1 Hexagonal nut (M6) . . . . Snap pin . . . . . . . . . . . . . Screws (M5 × 10) . . . . . . Hexagonal torque wrench . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 1 4 1 Caution: • Mounting should be done by a qualified technician. • Make sure that the mounting (ceiling) area has sufficient strength. • Read the enclosed mounting instructions thoroughly before starting. • Do not use an electric screwdriver or impact driver to tighten screws. Use a torque driver or hexagon torque wrench and tighten screws to the torque specified in the instructions. • When the product is no longer going to be used, have it disposed of quickly by a professional disposal service. ∅ 38 911– 1,481 (1-1/2) The illustration shows the ceiling mount bracket when it is combined with the ET-PKV100B and the PT-VW330/VX400 is attached. 145 132 ( 5-23/32) ( 5-3/16 ) 94 ( 3-11/16 ) 10 × 13 (13/32 × 1/2) 70 70 ( 2-3/4) ( 2-3/4) 256 (10-3/32) Projector 9 × 13 (11/32 × 1/2) ∅ 9 ( ∅ 11/ 32 ) 140 ( 5-1/2) 82 ( 3-7/32) ( 35-7/8 – 58-5/16 ) Adjustable in 30 mm (1-3/16 ) steps Dimensions ∅ 10 ( ∅ 13 / 32 ) 100 100 ( 3-15/16 ) ( 3-15/16 ) 200 (7-7/8 ) unit : mm (inch) NOTE: This illustration is not drawn to scale. Weights and dimensions shown are approximate. Specifications subject to change without notice. As of September 2011 SFL11A022 1/1