Transcript
Model: RPK87 Power Vector Amplifier Rack Mounting Kit Installation Power Vector amplifiers may be mounted in 19" racks using the RPK87 rack mounting kit. After having attached the rack ears, place the amplifier into the rack and secure it to the rack with appropriate hardware (not included). To Attach the Rack Ears: 1. If any feet have been attached to the bottom of the amplifier, remove them before proceeding. 2. Remove and discard the five cover screws from each side of the amplifier chassis, as shown above (same both sides). 3. Position the rack ears as shown in the drawing above. 4. Replace the cover screws with the five screws included and tighten to secure the rack ears. Only use included screws to mount rack ears. Specifications subject to change without notice. © 2009 Bogen Communications, Inc. Part No. 54-2073-01B 0907 50 Spring Street, Ramsey, NJ 07446, U.S.A. Tel. 201-934-8500 • Fax: 201-934-9832 www.bogen.com
