Transcript
ADDENDUM to Owner’s Manual #93-1153 Isobar® 1111 W. 35th Street, Chicago, IL 60609 USA www.tripplite.com/support Ultra-Series Direct Plug-In Surge Suppressors MOUNTING TAB A mounting tab and screw are enclosed for permanent mounting of your Isobar Direct Plug-In Surge Suppressor. USE THIS TAB ONLY IF LOCAL REGULATIONS ALLOW PERMANENT MOUNTING OF YOUR SURGE SUPPRESSOR. WARNING DO NOT USE MOUNTING TAB AND SCREW IN CANADA. CANADIAN REGULATIONS PROHIBIT PERMANENT MOUNTING OF THE ISOBAR DIRECT PLUG-IN SURGE SUPPRESSOR. USE OF THE MOUNTING TAB WILL VOID ALL WARRANTIES AND INSURANCE OF THE ISOBAR DIRECT PLUG-IN SURGE SUPPRESSOR. If your local regulations allow permanent mounting, simply slide tab into slot on the top panel of the surge suppressor. Adjust tab until it is flush with the rear of the surge suppressor. Secure tab to surge suppressor with supplied screw. Secure surge suppressor to your receptacle’s cover plate with cover plate screw. CAUTION To reduce the risk of electric shock, disconnect power to the receptacle before installing or removing the Isobar. When removing receptacle’s cover plate screw, the cover plate may fall across plug pins or receptacle may become dislodged. Copyright © 2011 Tripp Lite. All rights reserved. Isobar® is a registered trademark of Tripp Lite. 201112054 93-1239.indd 1 201112054 93-1239 12/7/2011 2:56:31 PM