Download Miele KM 6388

Transcript
Problem solving guide
Problem
Cause and remedy
After the hob has been The system lock or safety lock is activated.
switched on  appears  Deactivate the system lock or safety lock (see
in the timer display for a
"System lock / Safety lock").
few seconds.

flashes in the
timer display and
the hob switches
off automatically.
One or more of the sensors are covered, e.g. by fin‐
ger contact, food boiling over or an object.
 Clean off any dirt or remove the object (see "Safe‐
ty switch-off").
After the hob has been The hob is in demonstration mode.
switched on  appears  Deactivate demo mode (see "Programming").
in the timer display for a
few seconds. The cook‐
ing zones do not heat
up.
A cooking zone
switches off automati‐
cally.
It has been operated for too long.
 You can use the cooking zone again by switching
it back on (see "Safety switch-off").
A cooking zone or the
whole hob switches off
automatically.
The overheating protection mechanism has been acti‐
vated.
 See "Overheating protection".
The Booster has deacti‐ The overheating protection mechanism has been acti‐
vated early automatical‐ vated.
ly.
 See "Overheating protection".
The cooking zone is not The overheating protection mechanism has been acti‐
working in the usual
vated.
way on the power set‐
 See "Overheating protection".
ting selected.
Power level 9 is auto‐
Operating both zones at power level 9 would exceed
matically reduced if you the permitted maximum power for the two zones.
select power level 9 on  Use a different cooking zone.
two linked cooking
zones at the same time.
44