Transcript
INSTALLATION INSTRUCTIONS FSB-4201 PANASONIC TC-22LT1 INTERFACE BRACKET Prior to assembly, unpack carton completely and verify contents. If you are missing any of the following components, please contact Customer Service at 1-800/582-6480 Figure 1 (1) Interface Bracket (2) Nylon Spacers, ½(#10) X 3/8” (1) 1/8” Hex Key (2) M4-.7 X 16mm Phillips Screws, Pan Head (2) M4-.7 X 10mm Phillips Screws, Pan Head (4) M4-.7 X 6mm Phillips Screws, Pan Head BEFORE PROCEEDING, READ INSTALLATION INSTRUCTIONS COMPLETELY CAUTION! LCD DISPLAYS ARE EXTREMELY FRAGILE. 1. Remove screws securing stand to display and remove stand. 2. Using four slotted holes of interface bracket (see Figure 2), align interface bracket with four mounting holes in the back, outer corners of the display. 3. Place Nylon spacers between display and interface bracket at top two mounting locations. 4. Using two M4-.7 X 16mm Phillips Screws (provided) at the upper mounting holes, secure bracket and Nylon spacers to display. Do not over tighten screws. 5. Using two M4-.7 X 10mm Phillips Screws (provided) at the lower mounting holes, secure bracket to display. Do not over tighten screws. Optional VESA Mounting 6. Using 1/8” hex key, remove (4) mounting buttons from adapter bracket. 7. Using four inside holes of interface bracket and M4-.7 X 6mm Phillips Screws (provided), secure interface bracket to any 75mm VESA pattern. M4-.7 X 16mm Nylon Spacers Optional M4-.7 X 10mm Figure 2 8804-000035 12/10/03 CHIEF MANUFACTURING INC. 1-800-582-6480, Fax: 1-877-894-6918, Email: [email protected]