Download Blaupunkt LS 200e
Transcript
2.1ch Soundbar System mit Bluetooth LS 200e LS 200e 2 LS 200e 3 LS 200e 4 LS 200e 5 LS 200e 6 LS 200e 7 LS 200e 8 LS 200e 9 LS 200e 10 LS 200e 11 LS 200e 6 1 2 3 4 12 5 LS 200e 13 LS 200e 1 2 3 4 8 9 10 TruSurround HD, SRS and the symbol are trademarks of SRS Labs, Inc. 5 6 7 14 LS 200e 15 LS 200e 16 LS 200e TV Woofer Rear-L Front-L Center Rear-R Front-R Video DVD Player 17 LS 200e 1 10 2 3 4 5 6 7 8 13 9 14 11 12 CD TV BLU CO1 18 CO2 OPT LS 200e 19 LS 200e 20 LS 200e 21 LS 200e 22 LS 200e 23 LS 200e 24 LS 200e 25 LS 200e 26 LS 200e 27 LS 200e 28 LS 200e Conformity Model number: LS 200e Description: 2.1ch Soundbar System with Bluetooth Brand name: Blaupunkt Responsible party: M3 Electronic GmbH Gutenbergstrasse 5, D-65830 Kriftel. Germany Hereby, Blaupunkt Competence Center Audio M3 Electronic GmbH, declares that this Class 1 equipment is in compliance with the essential requirement and other relevant provisions of Directive 1999/5/EC. Letter of conformity can be obtained from [email protected]. Safety Instructions 1. READ INSTRUCTIONS – All the safety and operating instructions should be read before appliance's operated. 2. RETAIN INSTRUCTIONS - The safety and operating instructions should be retained for future reference. 3. HEED WARNINGS – All warnings on the appliance and in the operating instructions should be adhered to. 4. FOLLOW INSTRUCTIONS – All operating instructions should be followed. 5. WATER AND MOISTURE – The appliance should not be used near water, for example, near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in web basement. 6. VENTILATION – The appliance should be situated so that its location or position does not interfere with its proper ventilation. Do not place on bed, sofa, rug or similar surface that may block the ventilation openings, in a built-in installation, such as a bookcase or cabinet that may impede the flow of air through the ventilation openings. 7. HEAT – The appliance should be situated away from heat sources such as radiators, stoves, or other appliances (including amplifiers) that produce heat. 8. POWER SOURCE – the appliance should be connected to power supply only of the type described in the operating instructions or as marked on the appliance. 9. POWER CORD PROTECTION – power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them. 10. POWER LINES – an outdoor antenna should be located away from power lines. 11. OBJECT AND LIQUID ENTRY – care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings. 29 LS 200e 12. ESD WARNING – the display does not function properly or not reaction to operation of any the control may due to the electrostatic discharge. Switch off and unplug the set. Reconnect after a few seconds. 13. DAMAGE REQUIRING SERVICE – the appliance should be serviced by qualified service personal when: a. the power-supply cord or plug has been damaged. b. Objects have fallen into, or liquid has been spilled into the appliance enclosure. c. The appliance has been exposed to rain. d. The appliance has been dropped, or the enclosure damaged. e. The appliance does not appear to operate normally. 14. SERVICING – the user should not attempt to service the appliance beyond that described in the user operation instructions. All other servicing should be referred to qualified service personnel. 15. DO ensure that all electrical connections (including the mains plug, extension leads and inter-connections between the pieces of equipment) are properly made and in accordance with the manufacturer's instructions. Switch off and unplug the power before making or changing connections. 16. Unplug this apparatus during lightning storms or when unused for long periods of time. 17. Never unplug your radio by pulling on the power cord. Always grasp the plug firmly and pull straight out from the outlet. 18. DON'T remove any fixed cover as this may expose dangerous voltages. 19. DON'T place hot objects or naked flame sources such as lighted candles or nightlight on, or close to equipment. High temperatures can melt plastic and lead to fires. 20. DON'T leave equipment switched on when it is unattended unless it is specifically stated that it is designed for unattended operation. Switch off using the switch on the equipment and make sure that your family knows how to do this. Special arrangements may need to be made for infirm or handicapped people. 21. DON'T continue to operate the equipment if you are in any doubt about if it's working normally or if it's damaged in any way. Switch it off, unplug the mains power and consult your dealer. 22. REPAIR OR REPLACE all electric service cords that have become frayed or otherwise damaged immediately. Do not use a cord that shows cracks or abrasion damage along its length, the plug, or the connector end. 23. DON'T place objects filled with liquids, such as vases on the apparatus. 24. Batteries shall not be exposed to excessive heat such as sunshine, fire or the like. 25. The mains plug shall remain readily operable. 30 LS 200e 26. Ensure a minimum distance of 5cm around the apparatus for sufficient ventilation. 27. The ventilation should not be impeded by covering the ventilation opening with items such as newspapers, table-cloths, curtains, etc. 28. The batteries should be drawn to the environmental aspects of batter y disposal. Front panel - controls and functions 6 1 2 3 4 1. STANDBY: Power Standby Button. 2. SOURCE: Mode Selection Button. 3. LED Display. 4. VOL-: Volume Downward Adjustment Button. 5. VOL+: Volume Upward Adjustment Button. 6. Remote Sensor. 31 5 LS 200e Rear panel - controls and functions 1 2 3 4 8 9 10 TruSurround HD, SRS and the symbol are trademarks of SRS Labs, Inc. 5 6 7 1. Optical Input. 2. Coaxial 1 Input. 3. TV Stereo Left Audio Input. 4. CD Stereo Left Audio Input. 5. Power On/Off Switch. 6. AC Power Cord. 7. Speaker Output. 8. Coaxial 2 Input. 9. TV Stereo Right Audio Input. 10. CD Stereo Right Audio Input. 11. Speaker Input. 32 LS 200e System connection instructions Video In To Stereo Output TV RCA Cable Woofer Rear-L Front-L Center Rear-R Front-R Video Out Video Audio Out DVD Player Notice: When DVD player is working and PCM mode is chosen, the device works; otherwise, the devise cannot recognize the source. 33 LS 200e Remote control 1 10 2 3 4 5 6 7 8 13 9 14 11 12 1. SOURCE: Input Mode Selection Button. CD TV BLU CO1 CO2 OPT 2. MUTE: Mute Function Button. 3. Bluetooth PLAY and PAUSE. 4. PREVIOUS track select on Bluetooth mode. 5. TREBLE+: Treble Upward Adjustment Button. 6. TREBLE-: Treble Downward Adjustment Button. 7. BASS+: Bass Upward Adjustment Button. 8. BASS-: Bass Downward Adjustment Button. 9. VOL-: Volume Downward Adjustment Button. 10. STANDBY: Power Standby. 11. NEXT track select on Bluetooth mode. 12. DSP: TV, Music, Movie sound effects mode Selection. 13. SRS Selection . 14. VOL-: Volume Upward Adjustment Button. 34 LS 200e Using the remote control 1. Insert the batteries Insert two 1.5V size AAA batteries into the compartment of the remote control. Make sure the polarity of the battery must be complying with which on the compartment. Notice: Do not use old battery together with new one. Do not throw the remote control down on the ground or tread on it. Please put out the batteries from the compartment when you do not use it for long extent of time. 2. Effective scope of the remote control The remote control is effective in a scope, which is less than 7 meters, and in an angel of 30 degrees from the remote control to the receiver in the center speaker. Notice: Do not put the remote control and the signal receiver under strong light. Do not place any barrier between the remote control and the receiver. Do not use this remote control at the same time when using any other one. Operation A. Switch On/Off the Product 1. Before turning on the system, please connect it according to the System Connection Instruction. 2. Connect AC power supply with this product. (Caution: Power source must be consistent with this product.) 3. Press on the POWER switch button on the Rear Panel of the main unit to switch on the system, the standby indicator will light up. Then press the STANDBY button on the remote controller to enter the normal status. Press the button on the remote controller once again to keep power in standby status. 4. The device will get into standby mode automatically when there is no input signal detected within 30 minutes. Press "STANDBY" button on remote control to wake up. B. VOLUME Selection 1. Press the VOL + button on the front of the main unit, or the VOL + button on the remote control to increase the volume. 2. Press the VOL - button on the front of the main unit, or the VOL - button on the remote control to decrease the volume. C. TREBLE Selection 1. Press the TREBLE + button on the remote control to increase the treble level. 2. Press the TREBLE - button on the remote control to decrease the treble level. D. BASS Selection 1. Press the BASS + button on the remote control to increase the bass level. 2. Press the BASS - button on the remote control to decrease the bass level. 35 LS 200e E. MUTE Selection 1. Press the MUTE button on the remote controller once to keep the performance silent. Press "Mute" again to cancel mute function and the main volume instruction light will be flashing. F. DSP Sound effects Selection 1. Press the DSP button on the remote control, TV, or MUSIC, or MOVIE sound effects the selection, the products will display 'E1', or 'E2', or 'E3'. G. SRS Selection 1. Press the 'SRS' button on the remote control, to switch between 'OFF' and 'ON'. The device is with built-in PCM decoder. When you choose PCM mode on your TV or DVD player, the device will decode the PCM source automatically. Is a trademark of SRS Labs, Inc. TruSurround HD technology is incorporated under license from SRS Labs, Inc. SRS TruSurround HD creates an immersive, feature-rich surround sound experience from two speakers, complete with rich bass, high frequency detail and clear dialog. H. Bluetooth Selection 1. First, press button 'INPUT' from remote control, the products will display 'BLU', it's means products have been Bluetooth status. then use any end user's audio with Bluetooth equipment to search. when the audio equipment showed 'LS 200e', so please enter and choice it with password '0000', the connecting is success when a boom sound output. The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, lnc. We are the licensee to use such marks. Further information please visit www.bluetooth.org/apps/content/ 36 LS 200e Specifications 1.Power Supply..........................................................................................................AC 230V/50Hz 2.Total Power Output...............................................................................................................150W 3.Subwoofer Power Output ......................................................................................................80W 4.Soundbar Power Output ..................................................................................................2 x 35W 5.Input Sensitivity (Subwoofer)............................................................................. 300mV 20mV 6.Input Sensitivity (Soundbar)................................................................................750mV 50mV 7.Speaker Impedance (Subwoofer)......................................................................................8 Ohm 8.Speaker Impedance (Soundbar)........................................................................................8 Ohm 9.S/N (A Weight).........................................................................................................................80dB 10.THD (1kHz, 1W)......................................................................................................................0.5% 11.Frequency Response (Subwoofer)...........................................................30Hz~150KHz 3dB 12.Frequency Response (Soundbar).............................................................200Hz~20KHz 3dB 13.L/R Separation (1kHz)..........................................................................................................30dB 14.L/R Balance (Stereo)............................................................................................................. 2dB This symbol on the product or in the instructions means that your electrical and electronic equipment should be disposed at the end of its life separately from your household waste. There are separate collection systems for recycling in the EU. For more information, please contact the local authority or your retailer where you purchased the product. All rights reserved by Blaupunkt Competence Center Audio M3 Electronic GmbH. This material may be reproduced, copied or distributed for personal use only. 37