Transcript
IPM-200 iPad™ IPM-200 Mounting Frame Installation Instructions 3130 East Miraloma Avenue Anaheim, CA 92806 USA USA and Canada Phone: 1.800.368.9700 Fax: 1.800.832.4888 Other Locations – Phone: (001).714.632.7100; Fax: (001).714.632.1044 ©Premier Mounts 2011 Parts List The IPM-200 open mounting frame securely holds the Apple iPad™ or iPad2™ (not included) in place and gives access to all iPad™ controls and connections. It fastens easily to any of Premier Mounts’ wall or table mounts (sold separately) using the VESA 100x100mm mounting pattern, allowing tilt, rotation, height and/or directional adjustments. Lock-It™ security hardware is included. M4 x 8mm Security Screw (Qty 4) Step 1 Are you installing an original iPad™ or iPad2™ to the IPM-200? M5 Security Allen Wrench (Qty 1) IPM-200 (Qty 1) Remove if using original iPad™ Step 3 If an original iPad™, remove the corner felt pads on the IPM-200. Then continue to step 2 below. Mounting tab on IPM-200 the arms on the IPM-200 ➊➊ Adjust so that the iPad™ fits snuggly inside the mount (Figure 1). ➋➋ Tighten the two (2) pre-installed If an iPad2™, continue to step 2 below. Phillips screws on the back of the IPM-200 to secure the arms (Figure 2). Figure 1 Remove if using original iPad™ Step 2 Phillips screws ➊➊ Extend the arms of the IPM-200. ➋➋ Insert the iPad™ in the IPM-200. Step 4 Each arm of the IPM-200 should fit over a corner of the iPad™. Figure 2 AM50S-B mount shown for illustration purposes only. Use the M5 security Allen wrench and four (4) M4 x 8mm security screws to attach the IPM-200 to any 100x100mm VESA mount. Follow the installation instructions included with the VESA mount. A A A A A = 100x100mm VESA mounting point • All trademarks are the property of the respective trademark owners. Installation Instructions 9531-056-011-00 Visit the Premier Mounts website at http://www.mounts.com