Transcript
Installation Guide Case components Removable side panel 140mm fan Remove 8 screws to disassemble the side panel Vent for USB3.0 cable 5.25" bezel Removable HDD cage Speed fan controller Power switch Reset switch Support MS/SD(SDHC) types of memory card 120mm fan Multi-media ports Support long VGA card Hardware list Screw (12) for Motherboard Thumb screw(28) for HDD mounting Cable tie (1) for cable Clamp (1) USB 3.0 to USB 2.0 converter (1) Screw (4) for power supply mounting Screw (16) for HDD mounting CD-ROM installation Hard disk installation for modularized HDD cage Loose left / right screws to release 5.25" module. Loose thumb screws. Secure the 2.5" HDD to the base of the cage, sit below CD-ROM Insert the HDD, fasten thumb screws to secure. Slide it out to release Insert the CD-ROM, fasten screws. 2.5" HDD installation Motherboard Support MS/SD(SDHC) types of memory card Install the M/B to the right-hand-side panel, yow may remove the side panel before you install the M/B. Red VCC White D- Green D+ Black Key GND Key Place the 2.5" HDD into the case, use the screws to secure. Removable lower HDD cage, to exchange for room to fit full size graphics card PSU installation Assembl power supply with PSU mounting bracket. Loos four thumb screws to remove the PSU mounting bracket. Removable fan module Push in gently. Fasten four thumb screws to the case to secure. I/O port installation USB 3.0 MIC EAR USB 3.0 Supports motherboard USB 3.0 20 Pin header USB 3.0 HD AUDIO Fan mounted with tool-less anti-vibration kit, slide outwards to remove. BLUE 10 BLACK PURPLE 8 YELLOW 6 BROWN 4 RED 2 9 7 5 3 1 GREEN KEY ORANGE N.C. GND+H.S. TUBE USB 3.0 to USB 2.0 converter Pin19 Pin1 USB Pin11 VCC RED D- WHITE D+ GREEN GND BLACK RED WHITE GREEN BLACK KEY VCC DD+ GND Pin10 C50.V3540.02-E