Siemens C10 User guide Download

Transcript
HWC_APStartup.fm
Wireless AP: startup
Discovery and registration: Wireless AP registration settings
●
Allow approved
If the HiPath Wireless Controller does not recognize the serial number, the operator is
prompted to create a configuration.
If it recognizes the serial number, it sends the configuration for that Wireless AP.
>
It may be advisable, for the initial set up of the network, to select the "Allow All"
option here. This is the most efficient way to get a large number of Wireless APs
registered with the HiPath Wireless Controller.
After that, you may want to reset this option to "Allow Approved", so that no
unapproved Wireless APs would be able to connect. You can modify the status
of an unapproved Wireless AP in the Access Approval screen.
Define the Security Mode for registering Wireless APs
1.
Select the Wireless APs tab in any screen. Click on AP Registration. The Wireless AP
Registration Mode screen appears.
2.
To allow all Wireless APs to connect, click this radio button (default mode)
To allow only approved Wireless APs to connect, click on this radio button.
Set the discovery timers
3.
Define the timing parameters for the "discovery" process:
Number of Retries
The default number of retries is 3.
Delay between Retries
4.
The default is 1 second
To save the above parameters, click the Save button.
A31003-W1010-A100-1-7619, July 2005
HiPath Wireless Controller, Access Points and Convergence Software V3.0: User Guide
47