Gigaset C300-C300A / USA-CAN EN / A31008-M2203-R301-1-3S19 / pabx.fm / 25.08.2010 Connecting the base to the PBX Connecting the base to the PBX The following settings are only necessary if your PBX requires them; see the PBX user guide. Dialing mode and Flash Changing the dialing mode The following dialing modes can be selected: u Tone dialing (DTMF) u Pulse dialing (PD). §Menu§ Open main menu. *#Q5# Press keys. ~ §OK§ Pulse dialing mode (PD). Or: ~ Q §OK§ Tone dialing (DTMF). Setting pauses Changing the pause after line seizure You can change the length of the pause that is inserted between pressing the talk key c and sending the number. §Menu§ Open main menu. *#Q5# O Press keys. ~ Enter number for the length of the pause (1 = 1 sec.; 2 = 3 secs.; 3 = 7 secs.) and press §OK§. Changing the pause after recall key You can change the length of the pause if your PBX requires this (refer to the user guide for your PBX). §Menu§ Open main menu. *#Q5# 4 Press keys. ~ Enter a digit for the length of the pause (1 = 800 ms; 2 = 1600 ms; 3 = 3200 ms) and press §OK§. Please note Tone dialing (DTMF) is now the most common dialing mode. Pulse dialing mode (PD) is only used for a few old PBXs. Version 4, 16.09.2005 Setting recall Your phone is preset for operation on the main connection. For operation on a PBX, you may have to change this value. Please refer to the user guide for your PBX. §Menu§ Open main menu. *#Q5# 2 Press keys. ~ Enter digits for the recall time and press §OK§. 0 = 80 ms; 1 = 100 ms; 2 = 120 ms; 3 = 400 ms; 4 = 250 ms; 5 = 300 ms; 6 = 600 ms; 7 = 800 ms 48 Switching temporarily to tone dialing (DTMF) If your PBX still operates with pulse dialing (PD), but you need tone dialing for a connection (e.g., to listen to the network mailbox), you must switch to tone dialing for the call. Prerequisite: You are conducting a call or have already dialed an external number. * Press the asterisk key. After the call ends, pulse dialing is automatically reactivated.